ELNA 7300 Instructions Manual page 90

Message
Reason
Machine will not sew with the Start/Stop
key because the foot control is connected.
The Twin Needle Key has been pressed
after selecting a stitch that is not
compatible with a twin needle inserted.
The Elongation Key has been pressed
after selecting a stitch that cannot be
elongated.
The Elongation Key has been pressed
after selecting a stitch that cannot be
elongated.
Auto thread cutting was interrupted by
power switching off machine. Power
switch is turned on again and auto thread
cutting must be completed.
The presser foot was raised and auto
thread cutting was not completed.
Machine stops because thread is not in
take up lever or tangled in bobbin area.
Feed dog was lowered during sewing.
Bobbin winder spindle locks during bobbin
winding.
The machine is malfunctioning because of
the item indicated. Example: "E1 error" –
error in initialization of stepping motor.
The LCD screen is abnormal.
90
What to Do
Unplug the foot control.
Select a different stitch or
sew with a single needle.
Elongation can only be
used with satin stitches
081 – 090.
Lower the feed dog.
Press the "Auto Thread
Cut" key.
Lower presser foot. Press
the "Auto Thread Cut" key.
Place thread in take up
lever or remove tangled
thread from bobbin area
and auto thread cutting
mechanism. Wait 15
seconds before restarting.
Do not move feed dog
lever during sewing.
Turn off power switch.
Remove tangled thread.
Contact your authorized
Elna dealer or service
center where you
purchased your machine.
Turn power switch off.
Wait 5 seconds and turn
power switch on.