Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kuppersbusch IGV4609.2
Summary of Contents for Kuppersbusch IGV4609.2
- Page 1 IGV4609.2...
-
Page 3: Table Of Contents
Table of contents Intended use ....4 Utensils ....14 Not suitable. -
Page 4: Intended Use
Intended use Switching off the appliance..25 Intended use Interrupting the programme ..26 Terminating the programme ..26 I n t e n d e d u s e This appliance is intended for Changing the programme. -
Page 5: Before You Switch On The Appliance
Safety instructions Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power that the back cable. of the dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface). -
Page 6: In Daily Use
Safety instructions If the dishwasher is installed Do not install the appliance below or above other near heat sources (radiators, domestic appliances, follow heat storage tanks, cookers the information for installation or other appliances which in combination with generate heat) and do not a dishwasher install under a hob. -
Page 7: Door Lock
Safety instructions Childproof lock (door lock) Warning D o o r l o c k Risk of injury! The description of the childproof lock is at the back in To prevent injuries, e.g. the envelope. caused by stumbling, open the dishwasher only briefly * depending on model in order to load and unload the dishwasher. - Page 8 Safety instructions Ensure that children do not Warning place fingers in the tablet Risk of scalding! collecting tray 1B. Small Open the door carefully when fingers could become the programme is still running. caught in the slots. There is a risk of hot water When opening and closing spraying out of the appliance.
-
Page 9: Protection Of The Environment
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c... -
Page 10: Appliance Interior
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Interior light * W a t e r s o f t e n i s y s t e m / S p e c i s a l t 1* Cutlery drawer To ensure good washing results, 12 Top basket... -
Page 11: Water Hardness Table
Water softening system/Special salt To change the setting: Using special salt 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before switching on the set value increases by one level; appliance. This ensures that overrun when the value of : has been special salt solution is immediately... -
Page 12: Detergents With Salt Component
Rinse aid Using detergents with salt Rinse aid component D e t e r g e n t s w i t h s a l t c o m p o n e n t R i n s e a i d As soon as the rinse-aid refill If combined detergents with a salt... -
Page 13: Setting Amount Of Rinse Aid
Rinse aid 3. Close cover until it clicks shut. Switching off rinse aid refill 4. To prevent excessive foam formation indicator during the next rinse cycle, remove any rinse aid which has run over with If the rinse-aid refill indicator H is a cloth. -
Page 14: Utensils
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –... -
Page 15: Cups And Glasses
Utensils Cups and glasses Pans Top basket 12 Bottom basket 1b Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 1B. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully. -
Page 16: Cutlery Drawer
Utensils Cutlery drawer F olding spikes * F o l d i n g s p i k e s Arrange the cutlery in the cutlery drawer * depending on model 1* as illustrated. Separately arranged The spikes can be folded down to cutlery is easier to remove after improve arrangement of pans, bowls washing. -
Page 17: Adjusting The Height Of The Basket
Detergent Adjusting the height of the Detergent basket D e t e r g e You can use tablets as well as powder The height of the upper utensils basket or liquid detergents for dishwashers, but 12 can be adjusted in 3 stages to never use washing up liquid. -
Page 18: Adding Detergent
Detergent Adding detergent If the utensils are only lightly soiled, 1. If the detergent dispenser 9" is still slightly less than the indicated amount closed, press the lock 9* to open of detergent is usually adequate. the detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online dispenser 9"... - Page 19 Detergent Notes You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue.
-
Page 20: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 21: Programme Selection
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling. -
Page 22: Operating The Appliance
Operating the appliance Switching on the appliance Operating the appliance 1. Turn on the tap fully. 2. Open the door. O p e r a t i i a n c e t h e a p p l 3. Switch on ON/OFF switch (. Programme data The Eco 50°... -
Page 23: Eco Drying
Operating the appliance Eco drying Optical display while the programme is running * O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g If you have selected the Eco 50°... -
Page 24: Remaining Running Time Display
Operating the appliance 6. Keep pressing programme 6. To delete timer programming, press button 3 until the required value, the P + or – button until h : e.g. : , is indicated on the digital is indicated on the digital display. display h. -
Page 25: Automatic Switch Off / Interior Light
Operating the appliance When Eco drying is switched on, the To change the setting: end of the programme is not 1. Press programme button 3. indicated by an acoustic signal. Each time the button is pressed, the set value increases by one level; when the value of : has been Automatic switch off after end... -
Page 26: Interrupting The Programme
Operating the appliance Interrupting the programme Intensive drying 1. Open the door. The final rinse uses a higher temperature which improves the drying 2. Switch off ON/OFF switch (. result. The running time may increase The LEDs go out. The programme is slightly. -
Page 27: Cleaning And Maintenance
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance C l e a n i a n d n a n c e m a i n t e and fascia with a damp cloth;... -
Page 28: Filters
Cleaning and maintenance Filters Spray arms The filters 1Z keep large foreign Limescale objects in the rinsing water away from and contaminants in the rinsing water the pump. These foreign objects may may block nozzles and bearings on the spray arms 1: occasionally block the filters. -
Page 29: Fault, What To Do
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t , w h a t d o ? the appliance from the power supply. Experience has shown that you can 2. -
Page 30: Fault Table
Fault, what to do? Fault table Fault Reason Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. - Page 31 Fault, what to do? Fault Reason Remedial action Error code : is lit. Waste water pump blocked or Clean pump and lock cover correctly. (See cover on the waste water pump is “Waste water pump”) not locked in position. Error code : is lit.
- Page 32 Fault, what to do? Fault Reason Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 33 Fault, what to do? Fault Reason Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 34 Fault, what to do? Fault Reason Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 35 Fault, what to do? Fault Reason Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
- Page 36 Fault, what to do? Fault Reason Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
- Page 37 Fault, what to do? Fault Reason Remedial action Door does not open Eco drying deactivated. Activate Eco drying (see chapter “Operating automatically at the end of the appliance”). the Eco 50° programme. Button lock has been activated. * Deactivate button lock (see chapter “Safety information”).
- Page 38 Fault, what to do? Fault Reason Remedial action Appliance stops in the Door not closed properly. Close the door. programme or programme Do not place utensils or fragrance Check whether rear panel is being pressed is interrupted. dispenser in the tablet collecting in, e.g.
-
Page 39: Customer Service
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service. -
Page 40: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 41: Warm Water Connection
Installation and connection Water pressure: 4. Release both buttons. The LED for button # flashes and At least 0.05 MPa (0.5 bar), maximum the digital display h displays the 1 MPa (10 bar). At a higher water factory setting : pressure: connect pressure-reducing 5. -
Page 42: Removing The Appliance
Installation and connection 8. Press START button ` until : Use only a residual current operated circuit-breaker which features is indicated on the digital display. the symbol ‚. Only this extension 9. Close the door. guarantees compliance with 10. Open door after approx. 1 minute. the currently valid regulations. - Page 44 K09-180016/02 *9001186122* 9001186122 (9602) 440MV...
Need help?
Do you have a question about the IGV4609.2 and is the answer not in the manual?
Questions and answers