Delta-T Devices SunScan SS1 User Manual page 63

Canopy analysis system
Table of Contents

Advertisement

SunScan Probe SS1-RL4
The probe is powered by 4 x AA cells. These should give about 500 hrs
operating time with radio usage.
Replace the batteries when the level has fallen near to 5 V (or 4.7 V
level for non-radio operation).
BF5 radio transmitter BF5-RL4
The transmitter is powered by 4 x AA cells. These should give 500 – 1000
hrs operating time. To check the battery:
Depress the on/off button. After a few seconds the red LED will flash
at 3-second intervals.
If no flash occurs, undo the four case screws, and fit or replace the 4
alkaline AA cells in the battery holder.
For an indication of the remaining battery life, you will need a
voltmeter. Open the case, and measure the battery voltage with the
transmitter module powered.
Replace the batteries when the voltage nears the recommended end
point of 5V.
Sunshine Sensor BF5
The BF5 is powered by 2 x AA cells. These should give typically about
one year's lifetime. (The BF5 battery check is fully detailed in the BF5
manual.)
To check the battery voltage:
Run SunRead in your PC and communicate with the BF5 through its
RS232 cable. The battery voltage is reported.
Alternatively, open the BF5 case (undo the four corner screws) and
measure the BF5 battery voltage with a voltmeter.
Replace the batteries when their voltage drops to 2 V.
SS1 User Manual v3.3
Technical Reference  63

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SunScan SS1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Sunscan ss1-com05010

Table of Contents