Checking The Type Of Access Point - Canon EOS 2000D Instruction Manual

Checking the Type of Access Point

To start with, check if the access point supports WPS* that allows easy
connection between Wi-Fi devices.
If you do not know if the access point you use is WPS-compatible, refer
to the access point instruction manual or other documentation.
* Wi-Fi Protected Setup
When WPS is supported

The following two connection methods are available. Connection
can be established easier with WPS (PBC mode).
• Connecting via WPS (PBC mode): Perform the operations
described on page 75 onwards.
• Connecting via WPS (PIN mode): Perform the operations
described on page 79 onwards.
When WPS is not supported

• Connecting to a detected network manually: Perform the
operations described on page 83 onwards.
Access Point Encryption
This camera supports the following options for [Authentication] and
[Encryption settings]. Therefore, the encryption used by the access
point must be one of the following.
[Authentication]: Open system, Shared key, or WPA/WPA2-PSK

[Encryption settings]: WEP, TKIP, or AES

If stealth functions of the access point are active, connection may

be disabled. Deactivate stealth functions.
When connecting to a network that has a network administrator, ask the

administrator about the detailed setting procedures.
If the network you use filters by MAC address, register the MAC address of
the camera at the access point. The MAC address can be checked on the
[General sett.] screen (p.116).
74