Carrier AquaSnap 30AWH-R Installation And Operation Manual page 17

Occupancy mode
5
setting
6 Night mode setting
Anti-legionella
7
temperature setting
8 Anti-legionella timer starts
9 Lock of wired controller
3. Configuration
the air purge mode; during the air purge mode, wired controller will be displayed
"PA", and only the "ON/OFF" button are valid to exit this mode.
j Press "up" or "down" button to set the value;
k Then press "confirm" button to confirm and exit user settings or you can also
press "settings" button to go to the next item.
0 - Home; 1- Eco; 2- Away
This is used to set up night mode for low noise during the night-time.
Press "up" or "down" button to set the value:
0 - Without night mode
1 - With night mode
If choosing 0, press "confirm" and exit user settings or you can also press "settings"
button to go to the next item;
If choosing 1, then follow the steps below:
j Press "confirm" button to set the start timer setting, then press "up" or "down"
button to set the time in hours;
k Press "confirm" to enter minute setting, then press "up" or "down" button to set
the time in minutes;
l Press the "confirm" button to enter the stop timer setting, then press "up" or
"down" button to set the time in hours;
m Press "confirm" button to enter minute settings, then press "up" or "down" button
to set the time in minutes;
n Next, press "confirm" to confirm and exit user settings or you can also press the
"settings" button to go to the next item.
Press the "up" or "down" button to set the value;
Temperature range: 60-70
j Press and hold "confirm" button to enter day settings, press "down" button to set
the day, then press the "confirm" button to confirm, after which the icon of the day
will remain lit up.
k Press and hold the "down" button to enter hour settings, then press "up" or "down"
button to select the time in hour, press the "confirm" button to confirm.
l Press and hold the "down" button to enter minute settings, then press "up" or
"down" button to select the time in minutes and press "confirm".
m Press and hold the "confirm" button to confirm and exit user settings or you can
also press "settings" button to go to the next item.
Used to lock the button of wired controller in case children touch by mistake; double
press the "settings" button to unlock.
j Press the "up" or "down" button to set the value;
k Next, press the "confirm" button to confirm and exit user settings or you can also
press the "settings" button to go to the next item.
0- Without lock
1- With lock
15
C, default as 60 C.
0 0