Related Manuals for Vornado 533 XT
Summary of Contents for Vornado 533 XT
- Page 1 533 XT WHOLE ROOM CIRCULATOR OWNER’S GUIDE READ AND SAVE THESE INSTRUCTIONS vornado.com...
- Page 2 We expect this If it is not, we product to be will make it perfect. right. vornado.com 800-234-0604 help@vornado.com English...
-
Page 3: Table Of Contents
CONTENTS Important Safety Instructions ............. 4 Features ....................7 Cleaning ....................8 Troubleshooting ................10 Warranty .................... 11 English... -
Page 4: Important Safety Instructions
See www.vornado.com to view, - Do not run cord under carpeting. Do not cover cord with throw download and print the most current version of these instructions. - Page 5 3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as - This appliance has a polarized plug (one blade is wider than the approved by Vornado Consumer Service. For an authorized other.) To reduce the risk of electric shock, this plug is intended to replacement fuse, please contact Vornado Consumer Service.
- Page 6 8. Plug your appliance into the outlet and turn the power on. 9. If the replacement fuse blows, a short-circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair. Fig.
-
Page 7: Features
FEATURES Save energy by maximizing the performance of heating and cooling systems. When you use a Vornado Air Circulator, you will not have to set your summertime thermostat as low or your wintertime thermostat as high. FINGER FRIENDLY DESIGN MULTIPLE SPEEDS Resists curious fingers. -
Page 8: Cleaning
CLEANING GRILLE REMOVAL Screwdriver required. WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing grille. 1. Remove the 3 screws located in between the ribs of the inlet grille at roughly 10, 2, Front Grille Clip Front Grille Clip and 6 o’clock positions. - Page 9 CLEANING BLADE REMOVAL Pliers recommended. WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing blade. 1. First, remove the nut from the shaft by turning the nut clockwise to loosen. Pull the blade straight out from the shaft.
-
Page 10: Troubleshooting
Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip when the user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified electrician to check the GFCI outlet. -
Page 11: Warranty
Vornado, at its discretion, will repair or replace the Product at no cost. parts is not recommended and any consequences will not be covered by support services or product warranties. - Page 12 Vornado Air, LLC 415 East 13th Street, Andover, Kansas 67002 800.234.0604 | vornado.com CL3-0903 RA, V00...
Need help?
Do you have a question about the 533 XT and is the answer not in the manual?
Questions and answers