EcoxGear SoundExtreme SEDS32 User Manual
EcoxGear SoundExtreme SEDS32 User Manual

EcoxGear SoundExtreme SEDS32 User Manual

Powersports amplified soundbar

Advertisement

Quick Links

SoundExtreme SEDS32
Models: GDI-EXSEDS3201AU
POWERSPORTS
AMPLIFIED
SOUNDBAR
User Guide
1

Advertisement

Table of Contents
loading

Summary of Contents for EcoxGear SoundExtreme SEDS32

  • Page 1 SoundExtreme SEDS32 Models: GDI-EXSEDS3201AU POWERSPORTS AMPLIFIED SOUNDBAR User Guide...
  • Page 2: Left Side

    SoundExtreme Layout Backlit Speakers Control Panel FRONT Backlit Woofer Backlit Woofer LEFT SIDE RIGHT SIDE Auxiliary Power Out 12V Power In SAE Backlit SAE Connector (Black) Connector (Red) Speakers Light Bar BACK...
  • Page 3 In/Out Connections USB Charging AUX-IN AUX-OUT Port Port (Black) Port (Gray) Do NOT use these connections if they are wet. AUX-IN: This input can be used to connect a CD player, MP3 player, etc. AUX-OUT: This output can be used to connect to an amplifier or to another speaker AUX-IN connection.
  • Page 4 Connecting to 12VDC Power Supply The SoundExtreme does not have an internal battery. It must be connected to an external 12VDC power supply to function. When you install the SoundExtreme to a battery or a voltage regulator on a golf cart, a boat, a quad bike, a UTV, or another vehicle, you need to make sure that your vehicle battery or battery pack terminal voltage is 12VDC.
  • Page 5 Installation: Gas Vehicle 1. Loosen the bolts on the battery terminals. Use Caution: Do NOT attempt to loosen bolts if battery is wet. Contact may cause electric shock and injury if wet. 2. Connect the BLACK wire to the Loosen Bolts BLACK, negative terminal, then the RED wire to the RED, positive terminal.
  • Page 6: Control Panel

    Controls 1. LED Indicators: Each of the 4 LEDs correspond to different functions: Power, Bluetooth, Mode, and Status. 2. Power Button: Press button to turn the SoundExtreme on / off. 3. Mode Button: Press button to cycle through the following modes: Bluetooth, EcoCast Transmitting, EcoCast Receiving, FM, and AUX-IN.
  • Page 7: Led Indicators

    Operations LED Indicators From left to right, the 4 LED Indicators correspond to Power, Bluetooth, Mode, and Status. 1. Power Solid Green: Power On No Light: Power Off 2. Bluetooth Flashing Blue: Bluetooth Paring Solid Blue: Bluetooth Connected 3. Mode Solid Blue: Speaker Mode Solid / Flashing Red: EcoCast Transmitting Mode Solid / Flashing Green: EcoCast Receiving Mode...
  • Page 8: Pairing A Bluetooth Device

    LED Indicator from the left) is not flashing, briefly press start pairing your device. 3. Navigate to your Bluetooth device’s setup screen, find ECOXGEAR and connect. If the connection is successful, the Bluetooth icon will be lit solid and your SoundExtreme will announce “Your phone is connected. ”...
  • Page 9 Play Music (Bluetooth Mode) After the SoundExtreme is connected to your Bluetooth device, press briefly on the SoundExtreme to play, press again to pause. Press briefly to play previous song. Press briefly to get the next song. Notes: · Pair and connect your Bluetooth device with SoundExtreme before using this feature.
  • Page 10 EcoCast – Broadcast Your Music to Multiple Speakers x100 When you have two or more SoundExtreme speakers, you can build a broadcast system by initiating EcoCast Transmitting Mode in one SoundExtreme speaker and broadcasting your music to one or more SoundExtreme speakers in EcoCast Receiving Mode.
  • Page 11 Transmitting Mode (Speaker A). If they are not automatically re-connected, please follow the above steps. · You can also pair the SoundExtreme with any other ECOXGEAR speaker bearing the EcoCast symbol · The EcoCast functionality is only available while using Bluetooth as your Audio Source at a maximum range of 30 feet between speakers.
  • Page 12: Accessory Mode

    Listening to FM Radio (FM Mode) Press briefly to cycle through to FM Mode. Press briefly to tune in a radio station. To “seek” (jump to the next available station), PRESS AND HOLD either button down for a few seconds until it starts to seek a station.
  • Page 13: Pairing Your Remote Control

    Remote Control Pairing Your Remote Control Before you use your Remote Control for the first time, pull and remove the plastic tab at the bottom of the Remote Control. Your Remote Control should be paired to your unit. IF NOT paired, please follow the steps below.
  • Page 14: Remote Switch

    After the SoundExtreme is connected to your Bluetooth device, press briefly to play, press again to pause. Press briefly to play previous song. Press briefly to get the next song. Press briefly to adjust the speaker volume. LED: Backlit Speakers Press briefly to turn on your speaker backlights.
  • Page 15 Mounting Your Speaker 1. To mount the speaker, first place the 2 Mounts on the ends of the SoundExtreme at your desired orientation and attach them using three or four (depending on the orientation of your mount) Button Head Bolts, each. Tighten securely. 2.
  • Page 16: Troubleshooting

    Troubleshooting The sound is distorted Try lowering the volume control of your connected device or musical instrument. Also, try to reduce the overall volume of the SoundExtreme. Cannot Pair With Bluetooth Device Make sure that your device is compatible with Bluetooth. Turn off your SoundExtreme and Bluetooth device, then power on and reconnect.
  • Page 17: Specifications

    Specifications Dimensions 114.3 mm 812.8 mm Unit + Mounts Height USB Output 146mm 5V, 2.1A Unit Weight EcoCast 7.5kg Using Qualcomm® Broadcast Audio technology Bluetooth Compliance EcoCast Range Bluetooth V 5.0 9.1 m between Casting Bluetooth Frequency Band speaker and Receiving speakers 2.402~2.480GHz ISM Spectrum Compatibility Modulation...
  • Page 18 1.) Use the ECOXGEAR speaker in accordance with any music or noise rules and regulations. 2.) Properly seal the ECOXGEAR prior and after each use when in humid or water environments to avoid water damage to the internal components. Salt water / air is particularly corrosive. Always make sure that the gaskets are sealed when in a salt...
  • Page 19 4.) Store your unit with all caps properly sealed to avoid long term internal moisture damage inside your unit. 5.) Return the ECOXGEAR to Enfinity if you suspect water ingress into the unit or if the unit has experienced a severe impact that may have affected the integrity of the unit to take on water.
  • Page 20: What's In The Box

    What’s in the Box SoundExtreme Speaker 2.4m Power Cable SoundExtreme SEDS32 Models: GDI-EXSEDS3200...20 POWERSPORTS AMPLIFIED Auxiliary Power Out Mating Connector SOUNDBAR User Guide SoundExtreme SoundExtreme (2x) ¼-20 SHCS Bolt – User Guide Remote Control 3.5” long (2x) Rubber Allen Wrench (2x) ¼-20 SHCS...

This manual is also suitable for:

Gdi-exseds3201au

Table of Contents