Independent Channel Configuration (Default Configuration); Parallel Channel Configuration - ABB PVI-3.0/3.6/4.2-TL-OUTD Product Manual

I
ndependent channel configuration (default configuration)
P
arallel channel configuration
11
This configuration involves the use of the two input channels (MPPT)
in independent mode. This means that the jumpers between the two
channels (positive and negative) of the DC input terminal block
must not be installed and the switch
must be set to "IND".
This configuration uses the two input channels (MPPT) connected in
parallel. This means that the jumpers between the two channels (posi-
tive and negative) of the DC input terminal block
and the switch located on the main board must be set to "PAR".
11
- 46 -
Скачано с сайта интернет магазина https://axiomplus.com.ua/
located on the main board
11
11
09
5 - Installation
09
must be installed
09