Table of Contents
Advertisement
TEW-212APBO Quick Installation Guide
Connect to the power source and the local network
Step 1 Connect the Ethernet cable from the TEW-212APBO router to the port on the
POE (Power over Ethernet) host (PH-110 Power LAN 1 port hub) labeled P-LAN
OUT.
Step 2 Connect a straight-through Ethernet cable from the LAN-IN port of the POE
host to a spare port on the hub or switch within the local network.
The steps described above are summarized in the Figure 3.2.
Figure 3.2: Connecting TEW-212APBO to the power source and to the network
In the next section, we will discuss the procedure to setup a computer on the local
network, so we can use it to configure the router.
6
Advertisement
Table of Contents
