Related Manuals for Lotus Mondo Series
Summary of Contents for Lotus Mondo Series
- Page 1 Mounting and User Instructions Lotus-Mondo Series Stoves (Lotus Mondo 1, Lotus Mondo 1 S, Lotus Mondo 2, Lotus Mondo 2 S) Version 2, 03/02-2017...
- Page 3 Introduction Congratulations on your new Lotus Wood Stove We sincerely trust that your Lotus Wood Stove will bring many happy hours for you. However, to benefit fully from your investment, you should read these instructions thoroughly. They contain some specific advice on how to benefit fully from your stove –...
- Page 4 Distance to Combustible Material For combustible material, such as combustible walls, furniutre, etc., for reasons of safety a number of minimum distances apply. The following minimum distances apply: Distance to non-combustible material For non-combustible material, there should be a distance of 80-100 mm in order that the stove may release and distribute the heat while you may clean on and around the stove.
- Page 5 Mean Values at testing to DS/EN 13240: Flues Gas Temperature: 359 C Flue Gas Mass Flow: 4,9 g/s Rate of Efficiency: Rated Output: 5.1 Kw Flue: 12 pa Chimney A good draught in your chimney is paramount to how well a stove will burn. Note that there should be access to cleaning doors.
- Page 6 Floor When placing your new Lotus stove on the floor, it should be put on a non- combustible plate, for instance of steel or stone material. The plate should be so...
-
Page 7: Use Of Stove
large that it will reach a minimum of 30 cm in front of the stove, and 15 cm at each side of the fireplace opening. Chimney Sweep When your new stove has been mounted, do remember to report the installation to the chimney sweep. -
Page 8: Sound Advice
Cleaning of Stove All Lotus stoves have been factory surface treated with original Senotherm lacquer in ”coke” or ”grey” colour. Due to this treatment, the stove will, during the first kindlings, exude a special odour but that will vanish after a few times. - Page 9 Your stove should also be cleaned inside regularly. Ashes, soot, and any tar residues are to be removed from pane and combustion chamber. Smoke baffle plates should be dismantled regularly to remove soot and dirt which will frequently settle behind the plates. Check at the same time whether there is free passage to the chimney.
- Page 10 Wood for your Lotus stove should have a diameter of 7-9 cm and be max. appr. 30 cm long as it will otherwise come too close to the stove sides (at the DS testing 25 cm long wood has been used).
-
Page 11: Operating Trouble
Operating Trouble In case of any operating trouble with your Lotus stove, you may find the cause of that below. If not, please do not hesitate to contact your Lotus distributor. Stove hard to control – burning too quickly If your stove is new, check our guide. -
Page 12: Warranty
WARRANTY Lotus Wood Stove – 10-Year Warranty From 1 September 2014, Lotus is offering a 10-year warranty instead of a five-year warranty. This warranty applies to stoves which are supplied by Lotus after this date. This warranty covers Lotus Wood Stove model _________ production no. - Page 13 Lotus Heating Systems A/S. This warranty does not cover damage caused by inappropriate, non-expert/incompetent use of the stove. If a product is returned to Lotus Heating Systems A/S, and the damage subsequently turns out not to be covered by this warranty, any costs incurred shall be incumbent on the customer.