Table of Contents
Advertisement
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
POLARIS - SERIES TBM 200 MH ( 8" ) - TYPE PHO / PBO / PVO
DOCUMENT NBR. :
A0460
1.0
INTRODUCTION
Your new Series TBM pump has been designed and manufactured to perform for many years
with a minimum of maintenance. However, parts will wear and need replacing eventually. The
period between maintenance will greatly depend on the service and your maintenance program.
Series TBM pumps are heavy duty submersible slurry pumps featuring motor armatures with a
nominal service factor up to 2 depending on pump wet end and motor combination.
Pumps with standard F-Class motors are designed to operate submersed in slurry or other water
based liquids with temperatures not exceeding 40C (104F).
60C (140F) temperatures and / or dry-running applications can be configured with an H-Class
motor and / or an optional water jacket.
Special High Temp rated motors to 90C (194F) and 95C (203F) are available for hot sump
applications. Special Low Temp rated motors to -25C (-13F) are also available.
A range of available motor seal options, starting with our continuous run dry capable internal
slurry seal, can be combined with our motor and wet end options to configure a submersible pump
package that can handle the most severe duties in applications across a broad spectrum of
industries.
Motor modules of series TBM can be ordered in standard configuration
CSA Certified, File No. LR19467-15 (Frames 140,180,210,250 & 360)
This manual has been compiled to help you minimize your maintenance and speed repairs when
required. Read and understand this manual.
Please provide the Serial Number of your equipment if additional manuals are needed.
WHEN ORDERING PARTS ALWAYS REFER TO PUMP SERIAL NUMBER.THIS NUMBER IS
REVISION:
or as explosion proof units per
Class 1, Groups C&D, Temperature code T3C
UL Listed, File No. E10822
CSA Certified, File No. LR19467-15 (Frame 320)
FOUND ON THE NAMEPLATE ON THE PUMP.
EFFECTIVE
3
DATE:
4of 29
03-02-2016
Advertisement
Table of Contents
