Polaris Sportsman 570 Owner's Manual For Maintenance And Safety page 125

Lights
High Beam Adjustment
The headlight beam can be adjusted slightly upward or downward. Use
the following procedure to make the adjustment.
1. Position the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall. Place the transmission in
PARK.
2. Measure the distance from the floor to the center of the headlight
and make a mark on the wall at the same height.
3. Start the engine. Turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of the
headlight beam should be two inches (5 cm) below the mark on the
wall. Include rider weight on the seat when measuring.
5. 570 SP Models:
The adjustment screw is located
on the right side of the headlight
pod. To adjust the beam, loosen
the screw. Adjust the headlamp
to the desired position, then
tighten the screw.
All Other Models:
The adjustment knob is located on the right side of the headlight
pod. Adjust the beam to the desired position by turning the knob
either clockwise or
x
counter-clockwise.
MAINTENANCE
25 ft.
(7.6 m)
Adjustment Screw
x
2" (5 cm)
123