Hardware Installation - TRENDnet TEG-424WS Quick Installation Manual

2. Hardware Installation

Note:
1. After hardware installation is complete, use the Web Smart Switch
Management Utility to configure the TEG-424WS. To access the Web Smart
Switch Management Utility, open your web browser, and enter the default IP
Address http://192.168.0.1 and default password "admin". Make sure your
computer and the TEG-424WS are configured to the same network
segment.
2. The Mini-GBIC slots are shared with Gigabit Ethernet ports 25 and 26.
When the Mini-GBIC slots are in use, Gigabit Ethernet ports 25 and 26 are
disabled.
1. Connect the Power Cord to the
rear of the TEG-424WS and then
to a power outlet.
2. Connect a CAT-5e / 6 RJ-45
network cable from the computer
to an available Ethernet port of the
TEG-424WS.
2
English