Table of Contents
Advertisement
Quick Links
Installation Guide for WRM-series Wall
WRM-250
WRM-300
SAFETY INSTRUCTIONS
1. Only entrust loudspeaker mounting equipment to experienced professionals. Also strictly follow the provided safety instructions.
Improperly installed mounting equipment may result in property damage, personal injury and/or liability for the installing
contractor.
2. Always use safety cables! This will prevent equipment from falling during/after setup and while exploiting.
3. Always check if the wall surface is structurally strong enough to support load. Make sure the wall and/or ceiling structure allows
to hold the weight of the speaker including its bracket.
4. Only use appropriate fasteners.
5. Always make sure to securely use and tighten/lock all mounting bolts provided. Loose bolts may become unscrewed over time
due to vibration which could potentially create a safety hazard when not tightened securely.
www.mnmounting.com
info@mnmounting.com
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
Installation Guide
WRM - series
Mounting Systems
Models:
WRM-250 HV
WRM-320
Advertisement
Table of Contents
Related Manuals for MN Mounting Solutions WRM-250 HV
Summary of Contents for MN Mounting Solutions WRM-250 HV
- Page 1 WRM - series Installation Guide for WRM-series Wall Mounting Systems Models: WRM-250 WRM-250 HV WRM-300 WRM-320 SAFETY INSTRUCTIONS 1. Only entrust loudspeaker mounting equipment to experienced professionals. Also strictly follow the provided safety instructions. Improperly installed mounting equipment may result in property damage, personal injury and/or liability for the installing contractor.
- Page 2 Installation Guide WRM - series Installation Instructions: 1. First, release the upper bolt which securing the speaker plate to the 2. Screw the speaker plate to the rear bracket arm. Now remove the speaker (4) holes of the loudspeaker by using all plate from the arm.
- Page 3 Installation Guide WRM - series 5. Press down on the top of the loudspeaker until it stops and then 4. Slide the speaker plate along with tighten the upper bolt of the speaker the loudspeaker onto the lower bolt of plate.
Need help?
Do you have a question about the WRM-250 HV and is the answer not in the manual?
Questions and answers