SERVICE AN
TO REPLACE
FUSE (See Fig. 29)
Replace with 30 amp automotive-type
plug-in fuse. The
fuse holder is located in the engine compartment, directly
in front of the dash.
FUSE
HOLDER
ADJUSTMENTS
ii
iiii NIIIII, ,NN,, ,,,,,,
,,,
I L,,JJU L_III JlJI,,UUL
HOOD
CONNECTOR
HOOD SPRING
HINGEBRACKET
FIG. 30
FIG, 29
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
•
Close hood.
INTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
•
Check wiring, See electrical wiring diagram in Repair
Parts section of this manual,
TO REMOVE
HOOD, GRILL
AND SIDE PAN-
ELS (See Fig's. 30 and 31)
•
Raise hood°
•
Unsnap headlight wire connector,
•
Stand at side of tractor,
Grasp hood and tilt forward
and lift off hinge brackets,
•
To reinstall,slide
hood pivot rod into slot in hinge
brackets, and carefully reinstall hood springs,
[
HOOD PIVOT ROD
HINGE BRACKET
SLOT
FIG. 31
23