Service And Adjustments; To Remove Mower; To Install Mower; To Level Mower Housing - Craftsman 917.25552 Owner's Manual

...................................... I,,L= i i ,i i i ill,i ,,,,,, r ' i i_ ,
ERV CE A D ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS;
. Depress clutch/brake pedal fully and set parking brake.
• Place gearshift lever in "NEUTRAL" position.
• Place attachment clutch in "DISENGAGED" position°
• Turn ignition key "OFF" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug,
................................. = HN,l= ,m,,,m,,i , N ,=
TRACTOR
TO REMOVE MOWER (See Fig. 17)
Mower will be easier to remove from the right side of uniL
Remove mower blade drive belt from engine pulley
only (See TO REPLACE MOWER BLADE DRIVE
BELT" through step removing belt from engine pulley)
• Remove retainer spring from clutch rod; pull clutch rod
out of clutch lever,
Pull retainer springs out of rear suspension trunnions,
Remove rear suspension trunnions from lift brackets.
Pull retainer springs from front hinge pins,
Remove hinge pins attaching parallel link to mower
and front axle
• Raise lift lever to [aise suspension arms Slide mower
out from under tractor,
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE
TRACTOR, THE R.H. AND L.H. SUS-
PENSION ARMS MUST BE REMOVED
FROM TRACTOR,
TO INSTALL MOWER (See Fig, 17)
• Raise attachment lift lever to its highest position.
• Slide mower under tractor with discharge guard to right
side of tractor
• Install parallel link to front axle and mower with hinge
pins, Secure hinge pins with retainer springs
• Install clutch rod in clutch lever and secure with retainer
spring
• Lower attachment lift lever to lower suspension arms,
Slide trunnions through lift bracket holes and secure
with retainer springs_
, Roll bett over engine pulley Make sure belt is inside all
pulley grooves and inside belt guides.
Raise attachment lift tever to raise mower,
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or
driveway Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" on page 3). If tires are
over or under inflated, you will not properly adjust your
mower
CLUTCH
CLUTCH LEVER RETAINER
ROD SPRING
CLUTCH
ROD
MF'T
BRACKET
RETAINER ENGINE
SPRING PULLEY
RETAINER
SPRINGS
_PARALL,EL
HINGE
PINS
SIDE-TO-SIDE ADJUSTMENT (See Figs18 and19) -
• Raise attachment lift lever to its highest position.
• Measure height from bottom of deck curl to ground
level at front corners of mower Distance "A" should be
the same_
• If distance "A" needs to be changed, snap out access
hole cover on left side of tractor above footrest.
To raise left side of mower, loosen nut "B" and tighten
nut "C".
To lower left side of mower, loosen nut "C" and tighten
nut "B".
• When distance "A" is equal, securely tighten nuts "B"
and "C".
: Replace access hole cover.
FIG. 17
18