..... i
CEA
ADJUSTM
NTS
TO REPLACE
FUSE (See Fig. 30)
Replace with 30 amp automotive-type
plug-in fuse.
The
fuse holder is located in the engine compartment,
directly
in front of the dash,
FUSE
HOLDER
i
SCREW
FIG, 31
FIG. 30
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
"
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
•
Check wiring. See electrical wiring diagram in Repair
Parts section of this manual.
TO REMOVE HOOD, GRILL AND SIDE PAN=
ELS (See Fig's. 31 and 32)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Remove screw at rear of each side panel.
°
Pivot hood and side panel forward and lift off tractor,
•
To replace, reverse above procedure.
WIRE
CONNECTION
--
FIG. 32
23