ASSEM
ii iii iii, u.,
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly easier
Standard
wrench sizes are listed,
(1) 5/16" wrench
(2) 7118" wrenches
(1) 1/2" wrench
(1) 9/16" wrench
(1) 3/4" wrench
Tire pressure gauge
Screwdriver
Utility knife
When right and left hand is mentioned in this manual, it
means when you are in the operating position (seated be-
hind the steering wheel),
LY
INSERT
1t
2-1/4" DIA, WASHER
TO REMOVE
UNIT FROM CARTON
UNPACK
CARTON
•
Remove all toose parts from carton (See page 6)
•
Cut, from top to bottom, all four corners of carton and
lay panels flat
ATTACH
STEERING
WHEEL
(See Fig. 1)
•
Sfide the steering bushing over the steering shaft
•
Raise steering shaft forward until screw holes in dash
line up with steering bushing.
Install two (2) sh@t
metal screws and tighten securely
\
•
Position steering boot over steering shaft
\
•
Place tabs of steering boot over slots in dash and push', k
down to secure
•
Slide steering wheel adapter onto upper steering shaft
•
Position front wheels of the tractor so they are pointing
straight forward
•
Position steering wheel so cross bars are horizontal//
(left to right) and slide onto adapter
/
,
Assemble large flat washer and 1/2-20 hex nut ar_tJ
tighten securely
•
Snap insert into center of steering wheel
•
Remove protective plastic from tractor hood
BEFORE
ROLLING
UNIT OFF SKID
(See Fig. 6)
IMPORTANT:
CHECK
FOR
AND
REMOVE
ANY
STAPLES
1N SKID THAT MAY PUNC-
TURE TIRES WHERE UNIT IS TO ROLL
OFF SKID.
•
Raise attachment lift lever to its highest position.
•
Release parking brake by depressing
clutch/brake
pedal.
•
Roll unit backwards off skid
STEERING
BUSHING
STEERING SHAFT
(ASS EMBLY POSITION)
STEERING
BOOT
STEERING SHAFT
(SHIPPING
POSITION)
FIG, 1
7