Fir
SERVICE AND ADJUSTMENTS
TO REPLACE
FUSE (See Fig. 30)
Replace with 30 amp automotive-type
plug-in fuse.
The
fuse holder is located in the engine compartment, directly
in front of the dash.
FUSE
HOLDER
FIG. 30
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting.
°
Check wiring. See electrical wiring diagram in Repair
Parts section of this manual.
TO REMOVE
HOOD AND GRILL
(See Fig. 31)
i
_
CAUTION:
Muffler is hot.
Be careful
!
when removing retainer spdngs from
hood pivot brackets.
°
Raise hood.
•
Unsnap headlight wire connector.
•
Remove retainer springs from hood pivot brackets.
°
Stand in front of tractor.
Grasp
hood at sides, tilt
forward and lift off of tractor.
•
To reinstall, slide hood pivot brackets
into slots in
frame.
Replace retainer springs.
o
Reconnect headlight wire connector and close hood.
HOOD
HEADLIGHT
WIRE
CONNECTOR
REMOVE
RETAINER
SPRINGS
FIG. 31
23