Table of Contents
Advertisement
Environment of Use and Storage
Does not use or store the instrument near any flammable chemicals such as alcohol, thinner, benzene, etc. Also, this
•
instrument is not a category AP or APG equipment. If chemicals are spilled or evaporate, it may result in fire or electric
shock through contact with electric parts inside the instruments. Also, some disinfectants are flammable. Be sure to take
WARNING
care when using them.
Do not install the instrument in a location with the conditions listed below. Otherwise, it may result in failure or malfunction,
•
fall or cause fire or injury.
WARNING
Close to facilities where water is used.
•
Where it will be exposed to direct sunlight.
•
Close to air-conditioner or ventilation equipment.
•
Close to heat source such as a heater.
•
Prone to vibration.
•
Insecure place.
•
Dusty environment.
•
Saline or sulfurous environment.
•
High temperature or humidity.
•
Freezing or condensation.
•
Do not place the storage case in a location with the conditions listed below.
Where the cable of the sensor unit will be strongly pulled when the sensor unit is put into the case, otherwise, the
•
cable may be damaged, resulting in fire or electric shock.
Where someone might get their foot caught in the cable of the sensor unit is put in the case. Otherwise they could trip
•
over, resulting in injury.
Disclaimer
The manufacturer assumes no liability for any failure or damage which may occur by using other
•
company's products
The manufacturer assumes no liability for any failure or damage that may occur from installing, relocating, modifying,
•
maintaining, or repairing the equipment by any personnel other than designated personnel by the manufacturer.
The manufacturer assumes no liability for any accidents or damage on the equipment which may
•
occur due to operations performed without following the relevant precautions or instructions in this
manual..
The manufacturer assumes no liability for any failure or damage due to natural disasters such as
•
fire, earthquake, flood, and lightning.
The manufacturer assumes no liability for erroneous diagnostic criteria or results.
•
The manufacturer assumes no liability for any failure or damage which may occur due to
•
operations performed for any purposes other than its intended use.
This equipment should be operated under the specified conditions. The manufacturer assumes no
•
liability for any failure or damage which may occur due to operations performed under conditions
other than those specified in this manual. For more information on the operating conditions, refer
to Appendices.
17
Advertisement
Table of Contents
