Lubrication; Greasing The Bearings - Toro TimeCutter SS 4200 Operator's Manual

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings (Figure 24 and Figure 25)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
Figure 24
1. Front caster tire
Figure 25
Located on the seat pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check tire pressure every
25 operating hours.
1
G014522
3. Grease every 25 operating
hours.
4. Engine
4. Connect a grease gun to each fitting (Figure 24 and
Figure 25). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
24