Stopping The Machine; Adjusting The Height Of Cut - Toro TimeCutter SS 4200 Operator's Manual

1. Move the motion control levers to neutral and
outward to the park position; disengage the blade
control switch.
WARNING
Removing you hands from the motion control
levers while the machine is in motion can result
in a loss of control causing harm to you or
bystanders.
Always stop the machine and move the motion
control levers to the park position before
adjusting the Smart Speed™ Control System.
2. Adjust the lever to the desired position.
Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion control
levers forward (Figure 16).
Figure 18
To go straight, apply equal pressure to both motion
control levers (Figure 16).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 16).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down as
you slowly pull the motion control levers rearward
(Figure 19).
To go straight, apply equal pressure to both motion
control levers (Figure 19).
To turn, release the pressure on the motion control
lever toward the direction you want to turn.
To stop, push the motion control levers to neutral.

Stopping the Machine

To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
G008952
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.

Adjusting the Height of Cut

Height-of-cut is controlled by the lever located to the
right of the operating position (Figure 20).
19
G008953
Figure 19