Related Manuals for Smeg WDN064SLDUK
Summary of Contents for Smeg WDN064SLDUK
- Page 1 WDN064SLDUK Washer-Dryer User Manual Document Number : 2820530858_EN/ 27-01-23.(01:08)
-
Page 2: Table Of Contents
Temperature Selection ....28 Table of Contents Spin Speed Selection..... 29 1 Safety Instructions......Drying Programmes....... 30 Intended Use........Washing and Drying Programmes 30 Safety of Children, Vulnerable 6.10 Programme and Consumption Persons and Pets ......Table ..........Electrical Safety......6.11 Auxiliary Function Selection.. - Page 3 Please read this user manual first! Dear Customer, Thank you for choosing Smeg product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents carefully before using the product.
-
Page 4: Safety Instructions
1 Safety Instructions This section includes the safety – Personnel kitchens of stores, instructions necessary to pre- offices and other work envir- vent the risk of personal injury or onments; material damage. – Ranches, Our company shall not be held –... -
Page 5: Electrical Safety
with, climb on top or inside the • The product should not be fed product. Check inside the via an external switching product before use. device such as a timer or con- • Use child lock to prevent chil- nected to a circuit that is regu- dren from intervening with the larly switched on and off by a product. -
Page 6: Handling Safety
clean water mains and water Handling Safety outlet are suitable. If not, call a • Unplug the product before qualified electrician and moving, remove the water out- plumber to have them make let and water main connec- the necessary arrangements. tions. -
Page 7: Operational Safety
not use the product without • Place the power cable and suitable grounding to local/na- houses in locations without tional regulations. risk of tripping. • Plug the product in a socket • Do not install the product be- with voltage and frequency val- hind a door, a sliding door or at ues suitable to those indicated another location that will pre-... - Page 8 • Do not use chemical solvents “loading door does not open” on the product. These materi- error in the Troubleshooting als contain an explosion risk. section. • Do not operate defective or • Do not wash elements contam- damaged products. Unplug the inated with gasoline, kerosene, product (or turn off the fuse it benzene, reducers, alcohol or...
-
Page 9: Drying Safety
– Wipe the door gasket and • Do not dry textile products that loading door glass with a dry contain predominantly foam, and clean cloth at the end of rubber or rubber-like parts (e.g. the programme. shower caps, waterproof tex- •... - Page 10 hot steam if you open the • If there is a problem that you cover without completing the cannot solve using the inform- cooling step. Risk of seething. ation given in the safety in- • If the drying programmes are structions section, turn off and interrupted (as a result of pro- unplug the machine and call an...
-
Page 11: Maintenance And Cleaning Safety
• Do not use softener or anti- Maintenance and static agent unless recommen- Cleaning Safety ded by the manufacturer. • Do not wash the product with • Products such as softener pressure washers, by spraying should be used in accordance vapour, water or pouring water. -
Page 12: Package Information
center for the recycling of electrical and electronic equipment. Please consult your local authorities to learn about these collec- tion centers. Compliance with RoHS Directive: The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive. -
Page 13: Technical Specifications
3 Technical Specifications Supplier’s name or commercial brand SMEG WDN064SLDUK Model name 7178554000 Washing capacity (cotton) (kg) Drying capacity (cotton) (kg) Maximum spin speed (cycle/min) 1400 Built-In Height (cm) Width (cm) Depth (cm) Single Water inlet / Double Water inlet... -
Page 14: Installation
4 Installation • Do not install the product at places where Please read the “Safety Instruc- temperature may fall below 0 ºC. Freez- tions” section first! ing might damage your product. • Leave a minimum space of 1 cm Your washing machine automatic- between the product and the furniture. -
Page 15: Removing Transportation Safety Bolts
Cover B WARNING Keep the transportation safety bolts in a safe place to reuse when the product needs to be moved again in the future. Install the transportation safety bolts in reverse order of the disas- sembly procedure. Never move the product without the transportation safety bolts properly Rest the tabs of Cover B against the lower fixed in place. -
Page 16: Connecting The Drain Hose To The
WARNING Make sure that the cold water con- nection is performed correctly dur- ing the installation of the product. Otherwise, your laundry may come out as hot at the end of the wash- ing cycle and thus they may be worn. -
Page 17: Adjusting The Stands
4.6 Adjusting the Stands • If the current supply to the fuse or breaker in the house is less than 13 Amps, have a qualified electrician install WARNING a 13 amp supply. In order to ensure that the product • The voltage specified in the "Technical operates more silently and vibra- specifications"... -
Page 18: Preliminary Preparation
2. Disconnect the water outlet and water Never carry the product without the main connections. 3 Drain all the water shipping bolts properly attached! that remains in the product. See Drain- Your product is so heavy that it ing Remaining Water and Cleaning the shall not be carried by one person. -
Page 19: Tips For Energy And Water Saving
5.3 Tips for Energy and Water Saving 5.5 Loading the Laundry Following information will help you use the 1. Open the loading door. product in an ecological and energy/water- 2. Put the laundry items into the product in efficient manner. a loose manner. -
Page 20: Using Detergent And Softener
( ) a syphon piece in the softener com- The loading door is locked while a partment, programme is running. The door ) there is a liquid detergent apparatus lock will open once the programme for liquid detergent use in the main wash- is completed. - Page 21 • Wash woollens at suggested programme • Clean with water at its place or by remov- with special detergent made specifically ing from its place when it is necessary. for woollens. Do not forget to place the apparatus in • Please review the programme descrip- the main washing compartment (com- tions part for suggested programme for partment no.
-
Page 22: Tips For Efficient Washing
• Do not use softener and starch in the • As bleach may cause skin irritation use same washing programme simultan- only small amounts (1/2 tea cups - ap- eously. proximately 50 ml and rinse the laundry • Wipe the inside of the product with a well. - Page 23 Powder and liquid deter- It may be necessary to gents recommended for pre-treat the stains or per- colours can be used at form prewash. dosages recommended Prefer liquid deter- Liquid detergents Powder and liquid deter- for heavily soiled gents produced suitable for colours gents recommended for clothes.
-
Page 24: Tips For Efficient Drying
5.9 Tips for Efficient Drying Programmes Washing and Cotton Dry Synthetic Dry Babyprotect+ Wash & Wear Drying It washes and It washes and Clothes such Sheets, bed- dries consecut- dries consecut- as shirts, t- dings, baby ively! Sheets, ively! Sheets, shirts, sweat- clothes, t- beddings, baby... -
Page 25: Operating The Product
SPECIAL CASE: At programme start of Cot- load is higher than half load; washing pro- tons and Cotton Eco programmes, display gramme will be adjusted accordingly and shows the duration of half load. It is the programme duration increased automatic- most common use case. -
Page 26: Symbols On The Display
6.2 Symbols on the Display 1 Temperature Indicator 2 Door Lock Engaged Indicator 3 Drying Level Indicators 4 Programme Tracking Indicators 5 Duration Information 6 Programme Start Indicator 7 Delayed Start Enabled Indicator 8 Child Lock Engaged Indicator 9 Auxiliary Function Indicators 5 10 Auxiliary Function Indicators 4 11 Auxiliary Function Indicator 1 12 Auxiliary Function Indicators 3... -
Page 27: Washing Programmes
Programmes are limited to the Symbols shown on the display are highest spin speed appropriate for schematic and may not match with that particular type of fabric. the product one-to-one. When selecting a programme, al- If you do not want to perform dry- ways consider the type of fabric, ing process after the programme colour, soiling level and permissible... -
Page 28: Temperature Selection
be washable at 40 °C or 60 °C in a single steam applied at the end of the programme cycle and dries them so that they can be reduce the wrinkles on your shirts. When put in a cupboard immediately. the quick wash function is selected, the Pre-treatment algorithm is executed. -
Page 29: Spin Speed Selection
temperature value is not the maximum This function holds the laundry in the final temperature that can be selected for the rinsing water. If you want to spin your laun- current programme. dry after the Rinse Hold function: Press the Temperature Adjustment button 1. -
Page 30: Drying Programmes
6.8 Drying Programmes When you will dry laundry consist- ing of towels and bathrobes only, load a maximum of 4,5 kilograms WARNING The machine automatically cleans of laundry. For the dry weight of the laundry, the lint that from the laundry during see Correct Load Capacity drying programme. -
Page 31: Programme And Consumption Table
• Anti Allergy Clean and Wear programme is de- signed to quickly wash and dry A steam step applied at the beginning of daily clothes that have been worn the program helps to soften the dirt. for a short time and are not heavily Use this programme to wash and quickly contaminated. - Page 32 *** : Eco 40-60 programme is a test pro- You can see the washing duration gramme according to 40 ° C temperature on the display of your machine selection, EU regulation EU / 2019/2014 while selecting a programme. De- and EN 60456: 2016 / A11: 2020 standard. pending on the amount of laundry Selection of 40 °C temperature and cup- you have loaded into your machine,...
-
Page 33: Auxiliary Function Selection
For drying: Auxiliary Functions Drying Level Tem- perat- Programme ure Se- lection °C Cotton Dry 3,90 1400 • • • • • Synthetic Dry 2,50 • • • • Anti Allergy 3,80 1400 • • • • • 30-90 Cotton 6kg 6,00 1400 •... -
Page 34: Auxiliary Functions
6.11.1 Auxiliary Functions When an auxiliary function button that cannot be selected with the • Pre-wash current programme is pressed, the A Prewash is only worthwhile for heavily washing machine will make a warn- soiled laundry. Not using the Prewash will ing sound. -
Page 35: Functions/Programmes Selec- Ted By Pressing The Function Keys For 3 Seconds
skins, etc.) to be effected by the minimal This is not a washing programme. detergent remnants on the laundry can be This is a maintenance programme. reduced. Do not turn this programme on when there is something inside the • Steam machine. -
Page 36: Drying Steps
When drying a small amount of laundry To activate the child lock: (maximum 2 items), the timed drying steps Press and hold the related auxiliary func- in Cotton or Synthetic dry programmes tion button for 3 seconds. After the count- should be selected. -
Page 37: Starting The Programme
Additional laundry can be added into the machine during the End Time countdown. At the end of the countdown, End Time indicator turns off, washing cycle starts and the time of the selected pro- In order for the End Time function to be ac- gramme appears on the display. -
Page 38: Changing The Selections After Programme Has Started
6.16 Changing the Selections After Opening the loading door in case of power failure: Programme has Started Adding laundry after the programme has In case of a power failure, you can use the loading door emergency started handle under the pump filter lid to If the water level in the machine is suitable manually open the loading door. -
Page 39: Cancelling The Programme
is not active and select a new programme. This action will cancel the current pro- gramme. The selected programme starts anew. If you turn the programme selection Changing the auxiliary function, speed button when the Child Lock is en- and temperature: abled, the programme will not be Depending on the step the programme has cancelled. -
Page 40: Cleaning The Loading Door And The Drum
3. Rinse drawer and syphon in the sink 7.3 Cleaning the Body and Control with plenty of warm water. Use gloves Panel or suitable brush to prevent contact of Wipe the body of the product with soapy residues in the drawer with your skin. water or non-corrosive mild gel detergents 4. -
Page 41: Troubleshooting
draining of washing water. Thus, the water will be drained without any problem and the service life of the pump will extend. If the product fails to drain water inside it, the pump filter is clogged. Filter must be cleaned whenever it is clogged or in every 3 months. - Page 42 • Product is leaning on a rigid item. >>> Programme cannot be started or selec- Make sure that the product is not leaning ted. on anything. • The product has switched to self-protec- tion mode due to a supply problem (line There is water leaking from the bottom voltage, water pressure, etc.).
- Page 43 Washing takes longer than specified in Programme duration does not count- the user manual. (*) down. (*) • Water pressure is low. >>> Product waits • There is unbalanced load in the product. until taking in adequate amount of water >>>...
- Page 44 • A higher temperature was selected. >>> Washing performance is poor: Stains Select the proper programme and tem- persist or the laundry is not whitened. perature according to the type and soiling (**) degree of the laundry. • Insufficient amount of detergent is used. >>>...
- Page 45 take this detergent during rinsing or • Excessive amount of detergent is used. softener step. Wash and clean the drawer >>> Use only sufficient amount of deter- with hot water. Put the detergent in the gent. correct compartment. • Detergent was stored under improper •...
- Page 46 Laundry comes off wet after the drying Machine does not dry. step. • Laundry might not be dried or the drying step might not be enabled. >>> Check if • The programme selected might not be suitable for the type of laundry. >>> the drying function is selected after the selected washing programme.
- Page 48 The original spare parts for some specific components are available for 10 years from the placing on the market of the last unit of the model. Visit our website to: Get usage advice, download user manuals, get service and repair information www.smeg.com/services/customer-service...