Advertisement
UNPACKING, ASSEMBLING & OPERATING
ATTENTION! The vacuum accessories are packed inside the vacuum tank.
UNPACKING YOUR VACUUM
Remove the entire contents of the carton, please note that the accessories are packed inside
the vacuum tank. To access these accessories, undo latches (A) Fig.3, remove the tank
cover/motor assembly (B) and then remove the accessories inside the tank.
WARNING! DO NOT CONNECT THE POWER CORD TO THE POWER SOURCE UNTIL THE
FOLLOWING ASSEMBLY AND SET-UP INSTRUCTIONS HAVE BEEN DONE.
INSTALLING THE CORRECT FILTER FOR THE APPLICATION
Before reinstalling the cover/motor assembly on, it is important to determine the desired
cleaning application, wet or dry vacuuming. Each cleaning application requires different filters.
When vacuuming dry materials, to ensure proper filtration, the foam filter should be used
when vacuuming coarse materials with low dust for maximum air flow. The re-usable filter can
and should be used together with the foam filter when vacuuming coarse and dusty materials.
Place the cover/motor assembly upside down, slide the foam filter (A) Fig.4 over the cage (B).
Then slide the re-usable filter over the foam filter.
When vacuuming wet materials, to ensure proper filtration, the foam filter must be installed.
Place the cover/motor assembly upside down, slide the foam filter (A) Fig.4 over the cage (B).
Reposition and secure the cover/motor assembly to the tank with both latches, Fig.5.
HOSE AND ACCESSORY ASSEMBLY
1) Insert one end of the hose (A) Fig.6 into the vacuum inlet (front of the vacuum) and twist
slightly to tighten into place.
2) Attach either the gulper tool (B) Fig.6, round brush or the crevice tool to the other end of the
hose (C).
DRY VACUUMING OPERATIONAL STEPS
Before vacuuming dry materials, it is important that you have read and understood the
safety rules in this manual.
1) Unplug the power cord from the power source.
2) Remove the cover/motor assembly by undoing the 2 side latches and install a clean and dry
foam filter. If the vacuuming operation is extremely dusty, install the re-usable filter over the
foam filter. If it is necessary to vacuum dry materials and you have just finished vacuuming
wet materials, the foam filter must be completely dried or else the foam filter will clog up
quickly and it will be difficult to clean. The foam filter can be dried quickly by running the
vacuum for 5-10 minutes without the hose installed.
3) Reposition and secure the cover/motor assembly to the tank using the 2 side latches.
4) Insert the hose into the inlet on the front of the vacuum and twist slightly to tighten.
5) Attach either the gulper tool, round brush or the crevice tool to the other end of the hose.
YOUR VACUUM
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Advertisement
