Advertisement
Step 2
å
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (T) to the RIGHT END (A). Use three BLACK 1/2" PAN HEAD SCREWS (20).
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
the inner cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the END.
Turn a SCREW into those holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
U
Push the black lever up and
pull the SLIDE from the RAIL.
433360
Open end
20
BLACK 1/2" PAN HEAD SCREW
(3 used in this step)
A
www.sauder.com/service
T
Use these holes.
T
Open end
7
Page 7
Advertisement
