ANTAIRA AMY-5133-AC-PD Quick Installation Manual

Antaira Technologies
AMY-5133-AC-PD
Industrial IEEE 802.11 AC 5GHz Wireless AP / Client Bridge
Quick Installation Guide
Version 1.0
(June 2023)
Tel: 1-844-268-2472
Fax: 1-714-671-9944
www.antaira.com
Package Check List
The package contains the following items:
● Quick installation guide
● AMY-5133-AC-PD
● Pole mounting bracket

Front Panel Layout

Slave and Master switch

Product Overview

System Interface/Performance

● All RJ45 ports support the auto MDI/MDI-X function
● Embedded 2*10/100/1000Tx RJ45 ports with 1*PoE+/PD
Port (30W)
● WLAN supports 5GHz Wi-Fi

Power Requirement

● 48VDC IN, 0.5A, IEEE 802.3at PoE+, OR
● 12VDC IN, 1.0A from DC Jack

Operating Temperature

● Standard operating temperature model: -30°C to 40°C

Case/Installation

● Plastic housing
● Pole and wall mount design

LED Indicators

LED
Power
WAN Port Blinking
LAN Port Blinking
WLAN Blinking
19020000000136
Description
On The device is powered on
Off The device is powered off
On Port linked
Data is transmitting or receiving data
Off No link
On Port linked
Data is transmitting or receiving data
Off No link
On The wireless radio is on
Data is transmitting or receiving over wireless
Off The wireless radio is off

Quick Installation

Ethernet Ports

RJ45 Ports (Auto MDI/MDI-X)
All RJ45 ports are auto-sensing for 10Base-T, 100Base-TX or
1000Base-T device connections. Please follow the wiring pin
assignment table below for Ethernet port installation.

RJ45 Ethernet Port Pin Outs

10Base-T,
Pins T568A Color T568B Color
100Base-TX
Pin 1 white/green stripe white/orange stripe Rx+
Pin 2 green solid orange solid Rx-
Pin 3 white/orange stripe white/green stripe Tx+
Pin 4 blue solid blue solid unused
Pin 5 white/blue stripe white/blue stripe unused
Pin 6 orange solid green solid Tx-
Pin 7 white/brown stripe white/brown stripe unused
Pin 8 brown solid brown solid unused
Industrial Wireless Access Points Mounting

Pole Mounting

This unit has a pole mounting strap in the
box. Place the mounting strap through the
slot on the back of the device and then
around the pole as shown on Figure 1.
Tighten the mounting strap to secure the
device.

Wall Mounting

This device has a built-in wall mount bracket. Use the screws to
screw the wall and then line the device with the bracket to the
screws and push down to mount.
To remove the device from the wall, push up to unmount.
1000
Base-T(X)
TP0+
TP0-
TP1+
TP2+
TP2-
TP1-
TP3+
TP3-
Figure 1