Omega MONZA TTG22T User Manual page 35

EN
4. Assembly instructionS
STEP 1: Wheel assembly
Secure the wheels (#4) to the wheel bracket with a flat washer Ø20 (#6), a thin hex nut M20x1.5 (#8) and a cotter pin Ø4x36 (#5).
Install the shaft cap (#7) on the end with a rubber hammer.
NOTE: Use a black plastic bushing to secure the shaft cap (#7) as shown in the picture below. Cover the black bushing on the axle
cap, and use a rubber/wood hammer to tap the end of the plastic bushing and secure the axle cap to the wheel.
STEP 2: Attach Tow Bar and Fender
1. Attach the tow bar (#2) to the hydraulic tank with the M12x35 (#35) hex bolt, Ø12 (#20) flat washer and M12 (#25) hex lock nut.
2. Secure the mudguards (# 89 and # 90) to the hydraulic tank with the hexagonal bolt M8x25 (# 69), the flat washer Ø8 (# 37),
the lock washer Ø8 (# 57) and the hexagonal lock nut M8 (# 38). Fix the rubber washer (# 131) between the mudguard and the
hydraulic tank.
35