Table of Contents
Advertisement
8
Section 1
®
IntelliChlor
SCG Control Panel
Salt Level Status LEDs
The IntelliChlor SCG checks the pool salinity water daily and displays the
levels as follows:
Green LED: Good salt. The pool water salt level is between 3300
ppm and 5000.
Green LED (Flashing): Salt level is above 5000 ppm. The salt level
is high which increases the risk of corrosion and deterioration of pool
equipment and surfaces in and around the pool.
Red LED: Low salt. The water salt level is below 3300 ppm. The
IntelliChlor SCG will be producing chlorine at reduced efficiency. It is
highly recommended to add salt. See (*) Note below.
Red LED: Very low salt . The water salt level has fallen below 2600
ppm. The IntelliChlor SCG will not produce chlorine until salt is
added. The IntelliChlor SCG is OFF. See (*) Note below.
NOTE (*): After every salt addition, pump should be allowed to
run for at least 24 hours for proper dilution. Salinity readings
should only be taken, after the dilution period.
Status LEDs
Cold Water: Shows the IntelliChlor SCG power status:
•
No Light: The IntelliChlor SCG is operating in the normal
temperature range (> 52° F (11° C)
•
Red: The IntelliChlor SCG is in "Standby" mode (system off,
no chlorine production) due to a cold water condition. The
IntelliChlor SCG will resume to normal operation mode,
including accurate salinity report, once water temperature
goes above 52° F (11° C).
Cell: Shows the status of the IntelliChlor SCG.
•
Green (flashing): The IntelliChlor SCG needs to be
inspected. The blades may have calcium buildup. The
IntelliChlor SCG is not producing chlorine.
•
Green: IntelliChlor SCG is good and producing chlorine
No Light: IntelliChlor SCG is off and not producing chlorine.
It may be in an off-period of the sanitizing cycle and will
return on shortly.
Flow: This light indicates the status of water flowing through the
IntelliChlor SCG.
•
Red: Insufficient water flow through the IntelliChlor SCG, no chlorine is being produced.
•
Green: Sufficient water flow to produce chlorine.
Sanitizer Output LED indicators: See page 8.
Less / More Buttons: Controls the percentage of the total output capacity that the IntelliChlor SCG is
®
IntelliChlor
Salt Chlorine Generator Installation and User's Guide
producing while the pump is on (see Sanitizer Output LED indicators above). See page 8.
Advertisement
Table of Contents
