Gas Furnace Checklist - Carrier 58SP0B Installation, Start-Up, Operating And Service And Maintenance Instructions

58SP0B/58SP1B: Installation, Start–Up, Operating and Service and Maintenance Instructions

GAS FURNACE CHECKLIST

Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Fig. 53 – Gas Furnace Checklist
46
Thermostat Humidifier Furnace Model Equipment Installation Date: ____________________________ GAS FURNACE CHECKLIST Serial #
Furnace Orientation: Indoor Coil __________(F) high LOW HEAT LEAVING AIR TEMPERATURE Firing rate = heat content (btu/cu. ft.) X size of the dial (cu. ft/rev) X # of rev. per 60 sec (rev/sec) X 3600 (sec/hr) OR use the "Gas Rate" chart in the startup and adjustment section of the installation manual Low fire_____________ in. FIRING RATE: MANIFOLD PRESSURE: High fire___________ in. W.C. Installed altitude __________________ Furnace Location_____________________________ Outdoor Unit ORIFICE #_____________ ____Upflow W.C. Downflow **Supply pressure should be checked with furnace and all other gas appliances running Horizontal Right (CLOCKED METER FOR NAT. GAS – assure only furnace is running) Horizontal Left Example- (1050 btu/cu. ft.) X (0.5 cu. f t ./rev.) X (2 revs./60sec) X (3600 sec/hr)= 63,000 btu/hr Gas Adjustment HIGH HEAT_________________ btu/hr LOCAL GAS HEAT CONTENT_____________(btu/cu. ft.) ______________________________ SPECIFIC GRAVITY________/cu. ft. __________(F) high (contact your local gas utility-not required for propane) RETURN AIR TEMPERATURE INLET SUPPLY PRESSURE** _________ (F) low ______________ in. _________ (F) low W.C. btu/hr
METAL: TEMPERATURE RISE B Vent Connector Type: ft. Chimney Liner Concentric (circle one) Termination Type: Pipe Dia_____________ # of Elbows_____________ Total Length _____________ +90 % VENTING SYSTEM The supply temperature should be measured away from the line of sight of the Heat Exchanger Temperature rise is equal to the supply air temp minus the return air temp @ steady state operation. (circle one) _________ (F) low 2 pipe (std) Vent Dia________Total Ht.________ Termination Locat i on: Vent Conn. Dia_______ Conn. Length ______ (circle one) Single Wall Roof Connector Rise Above Furnace _________ Sidewall MID-EFFICIENCY VENTING SYSTEM B vent __________(F) high ft. ft. # of Elbows________ ft.
A230014