Cleaning And Maintenance; Cheesemelter; Service - Viking V CM Series Installation, Operation & Owners Manual

Hide thumbs

Table of Contents

Available languages

TO AVOID RISK OF PERSONAL INJURY, BURNS OR DAMAGING UNIT

CAUTION

Allow the unit to cool before washing or rinsing. Hot steam can cause injury. It

may also damage the burners. Care should be taken around burner valves to

prevent soap/degreaser from getting into valve body and mixing with valve

grease

TO AVOID RISK OF DAMAGING UNIT

Do not scrape or spray anything onto the burner at any time. If the burner is

CAUTION

scraped and sprayed, the warranty will be void. Do not use any cleaner on

burner, cleaners will destroy the tiles. Care should be taken when cleaning

surfaces around or near burner to prevent damage to burner. Remove rack to

clean.

Cheesemelter, Salamander Broiler

Do not spray any liquid directly into the unit, it could damage

ceramic burner and will void the warranty.

1) With the burner in the "OFF" position, allow the unit to cool completely.

2) Wipe down the outside of the unit with a soft cloth or sponge using warm, mild soapy

water solution. Wipe dry immediately.

3) Remove rack for cleaning. Rack can be cleaned with warm, mild soapy water solution.

Thoroughly dry rack before reinstalling.

4) Remove drip tray, can be cleaned in sink with warm, mild soapy water solution.

Thoroughly dry tray before reinstalling.

5) Wipe down the inside of the unit (bottom, sides, and rear) with a soft cloth or sponge

using warm, mild soapy water solution. Wipe dry immediately.

6) If there is any grease build-up on the ceramic burner, use a pin needle to open the holes.

Turn the burner on, and allow the grease to burn away on its own.

Important:

DO NOT try to scrape away grease from the burner.

NOTE:

To maintain luster of stainless steel surfaces apply a thin coat of stainless steel cleaner

and wipe with a clean cotton cloth.

All Gas Fired Appliances

•

Inspect flue for grease and debris build up periodically, a dirty or plugged flue could

cause unit to not operate properly and allow build up of soot creating an unsafe

environment.

•

Remove any debris from flue opening, have a qualified technician and or cleaning service

clean flue of any excess grease.

Service

All warranty and non warranty repairs should be performed by qualified service

personnel. To locate authorized service in your area contact your dealer,

consultant or the manufacture.