Table of Contents
Advertisement
7. Push the retention frame downward and use a torque screwdriver to tighten the
screw in the middle.
8. For peak thermal performance, apply proper amount of thermal paste to the
bottom center of the heatsink. (Skip this step if there is pre-applied thermal paste.)
9. Lower the heatsink until it rests firmly in place after aligning the six screw holes
on its bottom with the motherboard's studs.
10. Tighten all screws in diagonal sequence with a torque screwdriver.
To avoid damaging the fins of the heatsink, always grip the heatsink along the axis of
∙
the fins. Holding a heatsink along the side might damage its fins or solder.
Confirm if your heatsink is firmly installed before turning on your system.
∙
8
32
CPU & Heatsink
7
Torque Screwdriver Settings
Screw Head:
Torque:
12.5-15 kgf·cm*
*12.5-15 kgf·cm
= 122.6~147 N·m
= 10.9~13 lbf·in
10
9
Torx T20
#5
#3
#2
#6
#4
#1
Advertisement
Table of Contents
