Preparation For Installation - Kenner KND800 User Manual

• The manufacturer declines all responsibility for any consequences resulting from failure to observe Good
Technical Practice when constructing closing structures (door, gates etc.), as well as from any deformation
which might occur during use.
• The manufacturer declines all responsibility for any consequences resulting from improper use of the
product, or any use which is different from that expected and specified in this manual.
• Do not modify the automation components, unless explicitly authorised by the manufacturer and supplier.
• Only use original parts for any maintenance or repair operation.
• The manufacturer and supplier decline all responsibility with respect to the automation safety and correct
operation when other supplier's components are used.
• Anything which is not expressly provided for this manual is not allowed and will void warranty.
• Dispose of packing materials (plastic, cardboard, polystyrene etc.) according to the provisions set out by
current standards. Keep plastic bags out of children's reach.
• Keep this manual and refer to it when necessary.

Preparation for Installation

Before proceeding to your opener installation, check if your gate structure is in accordance with the current
standards, especially as follows:
•
The gate sliding track is linear and horizontal, and the wheels are suitable, the gate should be
mounted and moving freely.
•
Check that the structure is sufficiently strong and rigid.
•
Make sure that the gate is plumb and level.
•
The fence posts must be mounted in concrete.
•
The gate should not bind or drag on the ground.
•
The opening and closing gate stops are in position.
WARNING: Remember that control devices are intended to facilitate gate operation but cannot solve
problems due to any defects or deficiency resulting from failure to carry out correct installation or maintenance.
Take the product out of its packing and inspect it for damage. Should it be damaged, contact your dealer.
Remember to dispose of packing materials (cardboard, polystyrene, nylon, etc.) according to the current
standards.
Refer to the following Figures for gate installation.
2