Installing The Magnets - Kenner KND800 User Manual

Installing the magnets

Before installing the magnets, make sure the gate opener is put in manual operation, (the clutch connected
with gear shaft is disengaged) and the mains power supply is disconnected for safety.
When viewing the gate from inside the property, no matter whether the gate opens to left or right,
the N pole magnet needs to be installed on the left side of the gate, and the S pole magnet needs
to be installed on the right side of the gate. Ensure magnet center aligns with the marked line above!
1. If the gate opens to the right:
Push the gate to the closed position by hand, place the S magnet bracket assembly on the rack directly
opposite the limit switch of the opener (make sure the horizontal distance between the magnet and the limit
switch of the opener is 25-30mm), and tighten the fixing screws of the magnet bracket.
Push the gate to the open position by hand, place the N magnet bracket assembly on the rack directly
opposite the limit switch of the opener (make sure the horizontal distance between the magnet and the limit
switch of the opener is 25-30mm), and tighten the fixing screws of the magnet bracket.
The magnet installation is complete.
2. If the gate opens to the left:
Push the gate to the closed position by hand, place the N magnet bracket assembly on the rack directly
opposite the opener limit switch (make sure the horizontal distance between the magnet and the opener limit
switch is 25-30mm), and tighten the fixing screws of the magnet bracket.
Push the gate to the open position by hand, place the S magnet bracket assembly on the rack directly
opposite the limit switch of the opener (make sure the horizontal distance between the magnet and the limit
switch of the opener is 25-30mm), and tighten the fixing screws of the magnet bracket.
7