Switching On/Off; Operation; Setting The Volume; Switching Playback Mode - Parkside PBRA 20-Li B2 Translation Of The Original Instructions

If you operate the radio with the plug-in
power adapter, the battery indicator (19)
does not appear on the display.

Switching on/off

Switching on the device
1. Press the power button (11). The dis-
play (9) lights up.
Switching off the device
2. Press the power button (11). All play-
backs stop and the display (9) switches
off.
If the volume is set to „0", the amplifi er
switches off after 10 seconds. The device
must be switched on again.

Operation

Ensure that the ambient tem-
perature does not exceed
25°C or fall below 0°C during
operation.

Setting the volume

When switching on/off, the volume auto-
matically changes to a preset value.
Increasing the volume
1. Turn the volume knob (14) in a clock-
wise direction.
Reducing the volume
2. Turn the volume knob (14) in an anti-
clockwise direction.

Switching playback mode

Press the Source button (17) repeatedly. The
radio will now cycle through the available
playback modes (DAB+, FM and Bluetooth
AUX and USB are only available for selec-
tion if a playback medium is connected via
the AUX sockets (5/24) or the USB port
(battery compartment) (25).

Operating as a radio (FM)

Pull up the antenna (3) so that it is vertical.
Press the Source button (17) repeatedly un-
til the time display (20) shows "FM".
The signal indicator (20) on the display (9)
shows the signal strength. If this is low, it is
advisable to initiate a channel search

Station search (FM)

Automatic search
1. Press and hold the Tune button (13) for
approx. 2 seconds. All stored stations
are deleted and the radio now auto-
matically scans the frequency band for
up to 30 receivable stations.
2. Press the Preset button (18). The list of
stations is now shown on the display.
3. Press the NEXT / PREV button (12/16)
to scroll through the list entries.
Alternatively, you can also scroll
through the list by turning the volume
control knob (14).
4. Push the volume control knob (14) to
confi rm the station selection. Alterna-
tively: The selection is automatically
applied after approx. 10 seconds.
Semi-automatic search
• Press and hold the NEXT button (12).
The radio now automatically searches
for the next receivable signal in as-
cending order.
• Press and hold the PREV button (16).
® ). The radio now automatically searches
for the next receivable signal in de-
scending order.
GB IE
33