Advertisement
IMPORTANT:
Before turning on the supply valve for the first
time, follow the steps below to clear sand, debris and rust
from the system:
Make sure water sure water supply is off. Remove valve END
by rotating it 1/8 turn counterclockwise.
While holding a container over the uncapped VALVE to
prevent splashing, turn water supply on and off a few times.
Leave water supply off.
Replace END by engaging lugs and rotating 1/8 turn
clockwise.
Make certain the top is turned to the locked
position. Valve may not turn on if top is not fully in the
locked position.
Turn on water supply. Check that water level is at the marked
water line.
Turn shut-off valve on and check for
leaks. If connections are squarely
assembled, a slight retightening of the
nuts will stop any leaks.
If toilet is leaking in between the tank
and bowl, carefully retighten the tank
bolts evenly. Check all bowl and tank
connections for leaks for several days.
Install the toilet seat according to the
seat manufacturer's installation
instructions.
1. Insert the scent flower into the plug.
2. Take out the tube. Fill fragrance into
the tube. Do not overfill to avoid
overflow.
3. Insert the plug into the tube.
4. Insert the tube into the hole on the
bamboo tank cover.
Caution:
The fragrance may stain the
surface of the bamboo tank cover and
cause
color
difference.Be careful when
filling
fragrance
into the tube and avoid
dropping
fragrance
onto the tank cover.
FILL FLOAT WITH
BALLAST
Test flush the toilet.
Periodically check all connections for
leaks for several days following
installation.
Set the tank cover in place on the tank.
1312740-T01-A
Fig.#14
14
Fig.#15
15
Fig.#16
16
-7-
1/8
1/8
1.
2.
3.
4.
Advertisement
