Table of Contents
Advertisement
User Manual
16 Port Gigabit Layer 2 Managed PoE Switch
SFP Port Connection
The IP16GESP2 only supports Gigabit fiber module. The process of installing a fiber
module on a switch is as follows:
•
•
•
Note:
•
•
•
Before Powering On
•
•
•
Device Initialisation
The switch automatically initialises when the power switch is turned on. Indicator
will appear the following situation:
•
•
•
•
10
Firstly, grasp the optic fiber module from the side, insert it smoothly along the
SFP port slot until the optic fiber module and switch are in close contact.
Secondly, confirm the Rx and Tx ports of the fiber module when connecting.
Insert one end of the fiber into the Rx and Tx ports, ensuring that the Tx and Rx
ends of the interface are connected correctly and the other end of the fiber is
connected to another device.
Thirdly, please check the corresponding indicator light status after power on.
If the light is blinking that means the link is properly connected, if the light is
off , the link has failed to connect. Please check the line to confirm that the
corresponding equipment is enabled.
Do not allow excessive bending of the fiber, the radius of curvature should not
be less than 10cm.
Ensure the cleanliness of the fiber surface.
Please do not look directly into the optical fiber connector with your eyes as
this may cause eye injury.
Check whether the outlet power supply meets the switch specifications.
Check the power, switches, racks and other equipment have been properly
grounded.
Check whether the switch and other network devices are connected properly.
After the power is turned on, the power indicator remains on, the other
indicator is off at this time.
After about 1 second, all lights except for the power light turn on for about 35
seconds and then turn off.
When the SYS light flashes, the system runs normally.
Port LED's indicates the connection status of each port, indicating that the
switch has started to work normally
Advertisement
Table of Contents
