Table of Contents
Advertisement
This section contains instructions on how to operate the dive computer and interpret
its displays. Each display has been carefully designed to provide important information
you will need to plan your dive or dive series.
You will find that the ínstrument is easy to use and read. Each display shows only the data
relevant to that specific diving situation. For example, while you are on a dive, surface
interval data is irrelevant and therefore not shown. On the other hand, while you are on the
surface after a dive, remaining no-decompression time for that dive is irrelevant and therefore
replaced with information for your next dive.
As described in Section 2.1, "Water Contacts", the dive computer is controlled with the
COM (common), PLAN/ON, and TIME/MODE contacts (Fig 3.1), as follows:
Activation:
Dive planning:
Clock:
touch the PLAN/ON and COM contacts.
once the instrument has been activated, touch
the PLAN/ON and COM contacts.
once the instrument has been activated, touch the
TIME/MODE and COM contacts for two seconds.
The time is then displayed for four seconds.
A
m
S
C
R
A
T
E
TIME
MODE
PLAN
COM
ON
LOG
HIS
ALT
SET
PLAN
A
m
S
C
R
A
T
E
TIME
MODE
PLAN
COM
ON
LOG
HIS
ALT
SET
PLAN
A
m
S
C
R
A
T
E
TIME
MODE
PLAN
COM
ON
LOG
HIS
ALT
SET
PLAN
Fig. 3.1 USING THE W ATER
CONTACTS
a) Activation and dive planning
b) Time display and menu based modes
c) Exit the modes
19
Hide quick links:
Advertisement
Table of Contents
