Dive Planning - Suunto Favor User Manual

After activation the Low Battery Warning is indicated by the battery symbol. If the
battery symbol is displayed in the surface mode or if the display is faded or weak, the
dive computer should not be used (Fig. 3.5). It indicates that the battery is too low to
operate the instrument. If the low battery symbol appears during a dive, you should
abort the dive and begin ascent to the surface.
NOTE: The backlight of the LUX/LUX S models can not be activated, when the low
battery warning is indicated by the battery symbol.
NOTE: Temperature affects the battery voltage. If the dive computer is stored at
temperatures below freezing point, the low battery warning may be displayed even
though the battery has enough capacity in warmer conditions. Make sure that the low
battery warning disappears before diving.
It is possible at any time on the surface to enter the DIVE PLANNING mode, simply by
touching the PLAN/ON and COM contacts. The display will rapidly cycle through the
no-decompression limits for various depths from 9 m [30 ft] to 45 m [150 ft] in 3 m [10 ft]
increments (Fig. 3.6). It takes about 45 seconds to run through the complete cycle, after
which the dive computer will automatically return to the READY display.
Higher personal/ altitude adjustment modes will shorten the no-decompression time
limits. These limits at different personal/ altitude adjustment mode selections are shown
in Tables 6.1 and 6.2 in Section 6.1, "OPERATING PRINCIPLES".
A
S
C
R
A
T
E
A1
NO DEC TIME
DIVE
DIVE
TIME
LOG HIS ALT SET PLAN
Fig. 3.6 DIVE PLANNING
The no-decompression time limit at 30.0 m
[100 ft] is 14 minutes in A1 mode.
m
25