Installation; Unpacking; Installing Components; Selecting The Location - OHAUS VALOR 5000 H Series Instruction Manual

EN-5

2 INSTALLATION

2.1 Unpacking

Unpack and verify that the following components have been included:
Save the packaging material. Repack the scale in the original packaging to ensure safe storage or
transport of the product.

2.2 Installing Components

Place the weighing pan securely over the four load pads on the top of the scale. If using the optional
foot switch, plug the foot switch connection into the appropriate receptacle on the underside of the
scale (refer to Figure 2-3).

2.3 Selecting the Location

Operate the scale on a firm, level surface. Avoid
locations with rapid temperature changes or
excessive dust, air currents, vibrations,
electromagnetic fields or heat.
Adjust the leveling feet so that the bubble is
centered in the circle of the level indicator.
Figure 2-2. Leveling Indicator.
NOTE: The scale should be leveled each time its location is changed.

2.4 Connecting Power

2.4.1

AC Power

Check to ensure that the voltage printed on the scale's data label matches your local line voltage.
If this is not the case, DO NOT connect the scale to the power supply. Contact an OHAUS dealer for
assistance.
Connect the AC adapter to the wall outlet. Connect the plug into the power receptacle on the underside
of the scale.
Foot Switch Connector
• Scale
• Weighing Pan
• AC Adapter
Figure 2-3. Bottom of Scale.
• Instruction Manual
• Warranty Card
• Weights and Measures Sealing Kit
Figure 2-1. Installing Scale Components.
Valor 5000 Series
Pan
Load pads x 4
Leveling feet x 4
Level Indicator
Power Receptacle