ION Air LP iT55F Quick Start Manual page 4

Features
1. Platter: Place your record here.
2. 45 RPM Adapter Holder: Holds the included 45
RPM adapter. When not using the adapter, please
place it in this holder.
3. Tonearm: The fixed tonearm can be raised and
lowered by hand, or by pressing the raise / lower
lever.
4. Arm Clip: This specially designed arm clip
secures the tonearm while at rest or when not in
use. The arm clip has been designed to remain in
the up position while unlocked.
5. Raise / Lower Lever: Raises and lowers the
tonearm.
6. 33 / 45 / 78 Switch: This switch controls the RPM
of the turntable platter.
Note: For best results when playing 78 RPM vinyl
records, use a 78 stylus (sold separately). Only
use a 78 stylus with 78 RPM vinyl records.
Purchase the iCT06rs 78 stylus at ionaudio.com.
7. Autostop switch: This switch turns autostop on
or off. When autostop is on, the platter will start
spinning when the tonearm is placed over the
record and stop spinning when the record has
reached the end. (When autostop is off, the platter
will always spin regardless of the position of the
tonearm.)
Note: If your vinyl record stops before it reaches
the end of the music, turn Autostop to the off
position for this particular record. This is generally
recommended for 45 RPM records.
8. Headphone Jack: Connect headphones (sold separately) to listen to your vinyl playback.
9. Bluetooth Button: Press this button to start Bluetooth pairing. If after 5 minutes no Bluetooth
speaker can be found to pair with, the Bluetooth transmitter will become inactive and the LED
will turn off. If currently connected, press this to disconnect from a currently connected
Bluetooth device.
10. Bluetooth LED: This LED blinks when pairing with a Bluetooth device. Once fully paired, the
LED will remain solid. The LED will be off when Bluetooth is inactive, and when the Air LP is
turned off.
11. Volume: Adjust this to control the
headphone and Bluetooth output level.
12. RCA Output*: The audio from a playing
vinyl record is sent to this line-level RCA
audio output.
connected to phono level devices.
13. USB Audio Output: Use the included USB cable to connect your turntable to your computer.
The USB connection will send audio from the turntable to your computer. Please see the
Air LP With Your Computer
14. Power Cable Input: Use the included adapter to connect to wall power.
15. Power Button: Press this button to turn Air LP on/off. Air LP Turntable will re-connect to your
last used Bluetooth Speaker when powering on, if it is in range.
16. Aux Input: Connect a CD player, digital media player, or other audio source to this 1/8" stereo
auxiliary input. The audio from the Aux Input is also transmitted over a Bluetooth connection.
4
This must not
section of this manual for information.
IMPORTANT: Place the included felt
slipmat on the platter; then place your
record on the felt slipmat to carefully hold
your records.
IMPORTANT: Remove the plastic cartridge
cover (needle cover) before operating the
turntable.
*WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your receiver
if you plug in a LINE level device into a
PHONO level input.
be
Using