Download Print this page
NuTone SPK80L Manual
NuTone SPK80L Manual

NuTone SPK80L Manual

Fan/light/speaker ventilator

Advertisement

Quick Links

FAN/LIGHT/SPEAKER VENTILATOR
SPK80L & SPK80NL
READ AND SAVE
THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in
the warranty.
2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnect-ing means to prevent power from being switched on
accidentally. When the service disconnect-ing means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service
panel.
3.
It is recommended to wear safety glasses and gloves during installation.
4. Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-
rated construction codes and standards.
5. Sufficient air is needed for proper combus-tion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent
backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire
Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Condi-tioning Engineers (ASHRAE), and the local code
authorities.
6. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the out-doors.
8. If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFCI (Ground Fault Circuit
Interrupter) - protected branch circuit.
9. Never place a switch where it can be reached from a tub or shower.
10. This unit must be grounded.
11. Monitor your fan for unusual sounds, smells and smoke. If any appear, turn off the fan immediately and replace it.
1

Advertisement

loading

Summary of Contents for NuTone SPK80L

  • Page 1 FAN/LIGHT/SPEAKER VENTILATOR SPK80L & SPK80NL READ AND SAVE THESE INSTRUCTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.
  • Page 2: Typical Installations

    CAUTION 1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. 2. This product is designed for ceiling installation only. This product is designed for installation in ceilings up to a 12/12 pitch. Ductwork must point up. DO NOT MOUNT THIS PRODUCT IN A WALL.
  • Page 3 TYPICAL INSTALLATIONS All additional framings must be 2x6 minimum HOUSING MOUNTED TO 2x4 TRUSS HOUSING MOUNTED TO “I” JOIST *Requires additional framing for mounting tabs. Discharge 90 to joists. *Requires additional framing for mounting tabs. Discharge 90 to joists. 4" ROUND DUCT POWER CABLE 4"...
  • Page 4 New Construction 1. Choose the location for your fan in the ceiling. For best possible performance, use the shortest pos-sible duct run and a minimum number of elbows. 2. Position mounting brackets against joist so that bottom edge of housing will be flush with finished ceiling. Additional positioning feature for 5/8”, 1”, &...
  • Page 5: Install The Ductwork

    INSTALL THE DUCTWORK NOTE: The duct connector has a counter-balanced damper flap. The flap will be “open” approx. 1” when duct connector is attached to housing. This design permits insulation to be in direct contact with fan/light housing per UL (Underwriters Laboratories) standards. The slightest backdraft, however, will close the damper flap, preventing air from entering unit or finished space.
  • Page 6: Attach The Grille

    Or insert a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver. Gently vacuum fan, motor and interior of housing with a dusting brush at-tachment. METAL AND ELECTRICAL PARTS SHOULD NEVER BE IMMERSED IN WATER. When it comes to quality home ventilations, Broan-NuTone is the brand you can depend on.

This manual is also suitable for:

Spk80nl