Advertisement
INSTALL THE DUCTWORK
NOTE: The duct connector has a counter-balanced damper flap. The flap will be "open" approx. 1" when duct connector is attached to housing. This design
permits insulation to be in direct contact with fan/light housing per UL (Underwriters Laboratories) standards. The slightest backdraft, however, will close the damper
flap, preventing air from entering unit or finished space.
1. Snap the damper/duct connector onto housing.
Make sure that tabs on the connector lock into slots in housing. Top of damper/duct connector should be flush with top of housing.
NOTE: Make sure damper flap is in place inside of
duct connector. If it is not:
2. Connect 4" round duct to damper/duct connector
and extend duct to outside through a roof or wall cap. Check damper to make sure that it opens freely. Tape all duct connections to make them secure
and air tight.
CONNECT THE WIRING
1. Wire unit following diagram. Run electrical cable as direct as possible to unit. Do not allow cable to touch sides or top of unit after instal-lation is
complete.
BLACK
WHITE
BLUE
DUAL CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC
LINE IN
Squeeze top and bottom of connector to
WHITE
RED
RECEPTACLE
(LIGHT/SPEAKER)
GROUND
(bare)
BLACK
RECEPTACLE
(FAN)
WIRING
PLATE
‚
snap flap back into place.
FLUSH
Advertisement
