Bissell CROSSWAVE CORDLESS PROFESSIONAL 2582H User Manual page 9

Using the 3-in-1 Docking Station
WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting.
NOTE: The unit will begin to charge once it is docked, assuming the 3-in-1 Docking
Station is plugged in. Charging will pause when running the Clean Out cycle. Once the
Clean Out cycle is complete, charging will resume.
1
Place unit on 3-in-1
Docking Station.
4
Hold down Clean Out
button on top of the Carry
Handle. The cycle only
runs when the button is
held down.
NOTE: The 3-in-1 Docking Station needs to be plugged into an outlet in order to run the
clean out cycle. If the Clean Out button is held down over a minute, the unit will stop
cleaning automatically.
2
Fill Rinse Cup with water.
5
15s
Hold down Clean Out
button for about 10 to
15 seconds to allow unit
to flush out and pick up
all the water. Repeat as
needed.
3
Pour water into the Rinse
Funnel on the 3-in-1
Docking Station to the
MAX fill line.
6
Grasp Brush Roll Window
at the front of the window
face and pull upward to
remove.
global.BISSELL.com
9