Extra Universal Serial Bus Headers (Usb2/3); Serial Ports; Glan1/2 (Ethernet Ports) - Supermicro X5DP8-G2 User Manual

Extra Universal Serial Bus
Headers
Extra USB headers (USB2/USB3
on the X5DP8-G2/X5DPE-G2/
X5DPi-G2, FPUSB0/FPUSB1 on the
X5DPR-8G2+/X5DPR-iG2+) can be
used for front side USB access.
You will need a USB cable (not in-
cluded) to use either connection.
Refer to the tables on the right for
pin definitions.
header (USB4) designated J27 is
also provided on the X5DP8-G2/
X5DPE-G2/X5DPi-G2.
Note: the X5DP8-G2/X5DPE-G2/
X5DPi-G2 boards all have an addi-
tional USB header (designated USB
4), which is located near the Chas-
sis Fan 3 header.
aware that this header is not a
Legacy-supported header.
means that any device attached to
this USB header will not operate
outside of the operating system.

Serial Ports

The COM1 serial port is located
under the parallel port (see Figure
2-3). See the table on the right for
pin definitions. The COM2 connec-
tor is a header on the motherboard
(see pp. 1-6, 1-8 for location).

GLAN1/2 (Ethernet Ports)

Two Ethernet ports (designated
GLAN1 and GLAN2) are located
beside the VGA port on the IO
backplane. These ports accept
RJ45 type cables.
An additional
You should be
This
2-11
Chapter 2: Installation
USB2 Pin
Definitions (J13)
Pin
Number Definition
2 Power
4 -
6 +
8 Ground
10 Key
Front Panel Universal Serial Bus Pin
Definitions
USB2/FPUSB0
Pin Pin
Number Definition Number
1 +5V 1
2 P0- 2
3 P0+ 3
4 Ground 4
5 N/A 5
Serial Port Pin Definitions
(COM1, COM2)
Pin Number Definition
1 DCD
2 RXD
3 TXD
4 DTR
5 Ground
Note: Pin 10 is included on the header but not on
the port.
USB3 Pin
Definitions (J14)
Pin
Number Definition
1 Power
3 -
5 +
7 Ground
9 Key
USB3/FPUSB1
Definition
+5V
P0-
P0+
Ground
Key
Pin Number Definition
6 DSR
7 RTS
8 CTS
9 RI
10 NC