Table of Contents
Advertisement
Chapter 3
Appendix
3-1 Configuring a RAID Set
RAID Levels
RAID 0
Minimum Num-
b e r o f H a r d
≥2
Drives
Number of hard
Array Capacity
drives * Size of the
smallest drive
Fault Tolerance
No
Before you begin, please prepare the following items:
• At least two SATA hard drives or SSDs.
use two hard drives with identical model and capacity).
• Windows setup disc.
• Motherboard driver disc.
• A USB thumb drive.
Configuring SATA Controllers
A. Installing hard drives
Install the hard drives/SSDs in the Intel
the power connectors from your power supply to the hard drives.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Steps:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Go to Settings\IO Ports\SATA And RST Configuration, make sure SATA Controller(s) is enabled. To
create RAID, set SATA Mode Selection to Intel RST Premium With Intel Optane System Acceleration.
Then save the settings and restart your computer. Note: When using a PCIe SSD, make sure to set the RST
Control PCIe Storage Devices item under Settings\IO Ports\SATA And RST Configuration to Manual.
Then depending the M.2 connector you use, set the corresponding PCIe Storage Dev on Port XX item to
RST Controlled. Finally, save the settings and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
C. UEFI RAID Configuration
Steps:
1. After the system reboot, enter BIOS Setup again. Then enter the Settings\IO Ports\Intel(R) Rapid Stor-
age Technology sub-menu.
2. On the Intel(R) Rapid Storage Technology menu, press <Enter> on Create RAID Volume to enter the
Create RAID Volume screen. Enter a volume name with 1~16 letters (letters cannot be special characters)
under the Name item and press <Enter>. Then, select a RAID level. RAID levels supported include RAID 0,
RAID 1, RAID 10, and RAID 5 (the selections available depend on the number of the hard drives being
installed). Next, use the down arrow key to move to Select Disks.
(Note 1) An M.2 PCIe SSD cannot be used to set up a RAID set either with an M.2 SATA SSD or a SATA hard
drive.
(Note 2) Refer to "Internal Connectors" for the installation notices for the M.2 and SATA connectors.
RAID 1
2
Size of the smallest
(Number of hard
drive
drives -1) * Size of
the smallest drive
Yes
(To ensure optimal performance, it is recommended that you
(Note 1)
(Note 2)
Chipset controlled connectors on the motherboard. Then connect
®
- 45 -
RAID 5
RAID 10
≥3
4
(Number of hard
drives/2) * Size of the
smallest drive
Yes
Yes
Advertisement
Table of Contents
