Honda CRF250F 2023 Owner's Manual page 101

Wheels
RIGHT REAR
(4) lug
(5) caliper bracket
92
Servicing Your Honda
(4)
(5)
(6)
(6) slot
Installation
1. Installation is the reverse order of removal.
Install the side collars into the wheel in their
original locations. Carefully fit the brake disc
between the pads to avoid scratching them.
Make sure the lug (4) on the caliper bracket
(5) is located in the slot (6) in the swingarm.
Check that the chain adjusters are installed
properly.
2. Adjust the drive chain (page 102).
3. Tighten the rear axle nut to the specified
torque:
80 lbf·ft (108 N·m, 11.0 kgf·m)
4. After installing the wheel, apply the brake
pedal several times, then check if the wheel
rotates freely. Recheck the wheel if the brake
drags or if the wheel does not rotate freely.
If a torque wrench was not used to install the
wheel, see your dealer as soon as possible to
verify proper assembly. Improper assembly
may lead to loss of braking capacity.