Table of Contents
Advertisement
Chapter 6: Advanced Chassis Setup
2. Installing/removing hot-swap SAS/SATA drives
The drive carriers are all easily accessible at the front of the chassis. These are
(with RAID enabled) hot-swap drives. To remove a carrier, push the release button
located beside the drive LEDs. Then swing the colored handle fully out and use it
to pull the unit straight out (see Figure 6-5).
Note: Your operating system must have RAID support to enable the hot-swap
capability of the SAS/SATA drives.
Figure 6-5. Removing a SAS/SATA Drive from the Server
6-5
Advertisement
Table of Contents
