Supermicro SUPERSERVER 6015TC-10G User Manual page 72

S S
UPER ERVER 6015TC-T/6015TC-10G User's Manual
PCI Confi guration
Access the submenu to make changes to the following settings for PCI devices.
Onboard GLAN-1/Onboard GLAN-2 OPROM Confi gure
Select Enabled to allow the system to boot from the GLAN1 connection,the GLAN2
connection or the 10 Gb LAN port. The options are Disabled and Enabled.
Default Primary Video Adapter
This feature allows the user to specify which video adapter to be used as the default
primary video adapter. The options are Other and Onboard Video.
Reset Confi guration Data
If set to Yes, this setting clears the Extended System Confi guration Data (ESCD)
area. The options are Yes and No.
PCI-Exp. x16
Access the submenu for each of the settings above to make changes to the fol-
lowing:
Option ROM Scan
When enabled, this setting will initialize the device expansion ROM. The options
are Enabled and Disabled.
Enable Master
This setting allows you to enable the selected device as the PCI bus master.
The options are Enabled and Disabled.
Latency Timer
This setting allows you to set the clock rate for the Bus Master. A high-priority,
high-throughout device may benefi t from a greater clock rate. The options are
Default, 0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h, 00E0h and Other. For
Unix, Novell and other Operating Systems, please select "Other". If a drive fails
after the installation of a new software, you might want to change this setting
and try again. Different OSes require different Bus Master clock rates.
Large Disk Access Mode
This setting determines how large hard drives are to be accessed. The options are
DOS or Other (for Unix, Novelle NetWare and other operating systems).
7-10