DeLonghi Dinamica ECAM35X.15 Instructions For Use Manual page 21

The grinding is too fine and the coffee is
delivered too slowly or not at all
FLASHING
FLASHING
If the water softener filter (C4) is present,
an air bubble may have been released in-
side the circuit, obstructing delivery
The pre-ground coffee used is too fine
and the coffee is delivered too slowly or
not at all
FLASHING
If the water softener filter (C4) is present,
FLASHING
an air bubble may have been released in-
side the circuit, obstructing delivery
A LONG coffee with pre-ground coffee
has been requested
FLASHING
+ OK
ON STEADILY
Too much coffee has been used
ON STEADILY
FLASHING
Repeat coffee delivery and turn the grinding ad-
justment dial (A5 - fig. 8) one click clockwise to-
wards "7" while the coffee mill is in operation. If
after making at least 2 coffees delivery is still too
slow, repeat the correction procedure, turning
the grinding adjustment dial another click until
delivery is correct (see section "15.1 Adjusting
the coffee mill"). If the problem persists, make
sure the water tank (A17) is fully inserted, turn
the steam/hot water dial (A22) to the I position
and deliver a little water until the flow is regular.
Deliver a little water by turning the steam/hot
water dial (A22) to the I position until the flow
is regular.
Repeat coffee delivery using less pre-ground
coffee, or a different type. If the problem persists,
make sure the water tank (A17) is fully inserted,
turn the steam/hot water dial (A22) to the I
position and deliver a little water until the flow
is regular.
Deliver a little water by turning the steam/hot
water dial (A22) to the I position until the flow
is regular.
Put one level measure (C2) of pre-ground cof-
fee into the pre-ground coffee funnel (A4) and
press
preparation.
Select a lighter taste by pressing
reduce the quantity of pre-ground coffee.
20
OK (B15) to continue and complete
(B8) or