Cleaning And Maintenance - Brabantia D10-2PLA Instruction Manual

USING THE TABLE BLENDER
1. To switch on the appliance, turn the knob (9) to "ON" position. The Indication
light (10) will be illuminated.
2. To use the programmed function, turn the knob to "ON" position. The lighT
on the three buttons (5, 6, 7) will be illuminated. Press the programmed button, the
light on the specific button will be illuminated. When the program finished, the unit
will back to standby mode.
3. To control the rotary speed, turn the knob between "MIN" & "MAX" position.
Crush ice button
Press this button to crush the ice. The appliance starts crushing according to the pre-set
speed profile. The unit will stop automatically after the end of program. Press the button
again during operation will terminate the program and back to standby mode.
Smoothie button
Press this button to make delicious smoothies. The appliance starts mixing according to
the pre-set speed profile. The unit will stop automatically after the end of program. Press
the button again during operation will terminate the program and back to standby
mode.
Pulse button
Press this button to run the pulse mode. The unit operates only when pulse button was
pressed.
Tips
1. Do not blend dry, thick or heavy mixtures for more than 10 seconds continuously.
Let the appliance cool down to room temperature before continue operating the
appliance again.
2. Blend Ice, not more than 2 seconds continuously.
3. Do not place the lid into a dishwasher or boiling water, the lid may deform.
Clean the attachment by warm water is recommended.
4. Always hold the edge of the lid while operating the blender.
5. After every max operation period, please let the appliance cool down
to room temperature before continue operating the appliance again.

CLEANING AND MAINTENANCE

Disassembling and cleaning the Table Blender
1. Put the base unit (8) on a flat, dry table. Ensure that the control knob(9) is in
the off position and that the power cord is unplugged.